When translating the SRS instruction, handle the "store registers
to stack of current mode" case in the helper function rather than
inline. This means the generated code does not make assumptions
about the current CPU mode which might not be valid when the TB
is executed later.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
VSQRTS always uses the standard FPSCR value as it is a Neon instruction.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Add support to the ARM helper routines for a second fp_status value
which should be used for operations which the ARM ARM indicates use
"ARM standard floating-point arithmetic" rather than being controlled
by the rounding/flush/NaN settings in the FPSCR.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
The implementation of the ARM VRSQRTS instruction (which calculates
(3 - op1 * op2) / 2) was missing the division operation. It also
did not handle the special cases of (0,inf) and (inf,0).
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Wire up the new softfloat support for flushing input denormals
to zero on ARM. The FPSCR FZ bit enables flush-to-zero for
both inputs and outputs, but the reporting of when inputs are
flushed to zero is via a separate IDC bit rather than the UFC
(underflow) bit used when output denormals are flushed to zero.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Acked-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
When handling a write to the ARM FPSCR, set the softfloat cumulative
exception flags from the cumulative flags in the FPSCR, not the
exception-enable bits. Also don't apply a mask: vfp_exceptbits_to_host
will only look at the correct bits anyway.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Acked-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Use the softfloat conversion routines for conversion to 16 bit
integers, because just casting to a 16 bit type truncates the
value rather than saturating it at 16-bit MAXINT/MININT.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Nathan Froyd <froydnj@codesourcery.com>
VCVT of 16 bit fixed point to float should ignore the top 16 bits
of the source register. Cast to int16_t and friends rather than
int16 -- the former is guaranteed exactly 16 bits wide where the
latter is merely at least 16 bits wide (and so is usually 32 bits).
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Nathan Froyd <froydnj@codesourcery.com>
The ARM ARM defines that if the input to a single<->double conversion
is a NaN then the output is always forced to be a quiet NaN by setting
the most significant bit of the fraction part.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Nathan Froyd <froydnj@codesourcery.com>
The ARM architecture mandates that converting a NaN value to
integer gives zero (if Invalid Operation FP exceptions are
not being trapped). This isn't the behaviour of the SoftFloat
library, so NaNs must be special-cased.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Nathan Froyd <froydnj@codesourcery.com>
Expose the vfp_get_fpscr() and vfp_set_fpscr() functions to C
code as well as generated code, so we can use them to read and
write the FPSCR when saving and restoring VFP registers across
signal handlers in linux-user mode.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Riku Voipio <riku.voipio@nokia.com>
In linux-user mode, the XScale/iWMMXT coprocessors must be enabled
at reset so that we can run code that uses these instructions.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
fprintf_function uses format checking with GCC_FMT_ATTR.
Format errors were fixed in
* target-i386/helper.c
* target-mips/translate.c
* target-ppc/translate.c
Cc: Blue Swirl <blauwirbel@gmail.com>
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
Booting an arm kernel has been broken a while when booting from non zero start
address. This is due to the order of events: board init loads the kernel and
sets register 15 to the start address and then qemu_system_reset reset the cpu
making register 15 zero again.
This patch fixes the usage of the register 15 start address trick in
combination with arm_load_kernel.
Signed-off-by: Lars Munch <lars@segv.dk>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Move ARMv7-M PC/SP initialization to the CPU reset routine. Add a board
reset routine to call this. Also load values directly from ROM as
images have not been copied yet.
Avoid clearing the NVIC pointer on cpu reset.
Signed-off-by: Paul Brook <paul@codesourcery.com>
Don't set PAGE_EXEC for XN pages, to avoid a bypass of XN protection
checking if the page is already in the TLB.
Signed-off-by: Rabin Vincent <rabin@rab.in>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
QEMU uses a fixed page size for the CPU TLB. If the guest uses large
pages then we effectively split these into multiple smaller pages, and
populate the corresponding TLB entries on demand.
When the guest invalidates the TLB by virtual address we must invalidate
all entries covered by the large page. However the address used to
invalidate the entry may not be present in the QEMU TLB, so we do not
know which regions to clear.
Implementing a full vaiable size TLB is hard and slow, so just keep a
simple address/mask pair to record which addresses may have been mapped by
large pages. If the guest invalidates this region then flush the
whole TLB.
Signed-off-by: Paul Brook <paul@codesourcery.com>
Access the cp15.c13 TLS registers directly with TCG ops instead of with
a slow helper. If the the cp15 read/write was not TLS register access,
fall back to the cp15 helper.
This makes accessing __thread variables in linux-user when apps are compiled
with -mtp=cp15 possible. legal cp15 register to acces from linux-user are
already checked in cp15_user_ok.
While at it, make the cp15.c13 Thread ID registers available only on
ARMv6K and newer.
Signed-off-by: Riku Voipio <riku.voipio@nokia.com>
All other bits except for the EN in the VFP FPEXC register are defined
as subarchitecture specific and real functionality for any of the
other bits has not been implemented in QEMU. However, current code
allows modifying all bits in the VFP FPEXC register leading to
problems when guest code is writing 1's to the subarchitecture
specific bits and checking whether the bits stay up to verify the
existence of functionality which in fact does not exist in QEMU.
This patch has been revised to include the same behavior change in
the gdb register write function.
Signed-off-by: Juha Riihimäki <juha.riihimaki@nokia.com>
Acked-by: Laurent Desnogues <laurent.desnogues@gmail.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
(INT32_MIN / -1) triggers an overflow, and the result depends on the
host architecture (INT32_MIN on arm, -1 on ppc, SIGFPE on x86). Use a
test to output the correct value.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Acked-by: Laurent Desnogues <laurent.desnogues@gmail.com>
In the very least, a change like this requires discussion on the list.
The naming convention is goofy and it causes a massive merge problem. Something
like this _must_ be presented on the list first so people can provide input
and cope with it.
This reverts commit 99a0949b72.
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
According to ARM Cortex A8 Technical Reference Manual, the reset value for CP15 c1 auxiliary control
register is 2, not zero (page 3.12).
Signed-off-by: Riku Voipio <riku.voipio@iki.fi>
Acked-by: Laurent Desnogues <laurent.desnogues@gmail.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6771 c046a42c-6fe2-441c-8c8c-71466251a162
Fix remaining arm warnings - except for the mess in the NetWinder FP
emulator.
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6766 c046a42c-6fe2-441c-8c8c-71466251a162
Original idea&code by Kevin Wolf, split-up in two patches and added more
archs.
This patch introduces a flag to log CPU resets. Useful for tracing
unexpected resets (such as those triggered by x86 triple faults).
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6452 c046a42c-6fe2-441c-8c8c-71466251a162
EE state, just the associated system coprocessor registers. It is sufficient
to keep OS setup and context switching code happy.
Signed-off-by: Paul Brook <paul@codesourcery.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6104 c046a42c-6fe2-441c-8c8c-71466251a162
After a quick code review, it seems to be a bad cut-n-paste between
16-bit and 8-bit UADD/USUB, indeed UADD8/USUB8 tries to set GE bits by
pair instead of one at a time.
Besides, the addition operations (UADD8/UADD16) set GE bits to "NOT
carry" instead of "carry" (probably once again due to a copy of the
substraction code which sets flags to "NOT borrow")
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@4900 c046a42c-6fe2-441c-8c8c-71466251a162
helper.c
- copy reference c0_c2 to runtime c0_c2 and not c0_c1
op_helper.c
- remove old code (PARAM1, probably some left over from old dyngen)
that broke do_[us]sat
translate.c
- gen_smul_dual should sign-extend from 16 bit to 32 bit and not from
8 to 32
- disas_arm_insn:
* smlalxy: that was completely wrong; now the addition is
performed as for smlald
* pkhtb: optional ASR not taken into account (similar
* to [us]sat)
* pkhtb/pkhbt: tmp2 is dead
* smlald, smlsld, smuad, smusd, smlad, smlsd: rd
* and rn swapped
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@4898 c046a42c-6fe2-441c-8c8c-71466251a162
