thorpej
33a6994da1
Driver for Broadcom BCM5400-family Gig-E PHYs. Programming
...
information gleaned from FreeBSD.
2001-06-01 16:49:59 +00:00
tshiozak
4ce7dc7d21
add a new IANA-registered port, SSTP. (a well-known P2P protocol in Japan.)
2001-06-01 16:04:32 +00:00
thorpej
71cb790fb5
Add support for the Algorithmics P-4032 board. This is totally
...
untested, since I have no P-4032 board, but it's no worse than
the current situation, which is "totally non-working P-4032
support in the ARC port, of all places".
2001-06-01 16:00:03 +00:00
thorpej
23a3dc1508
If a bus doens't want to use an extent, don't force it to.
2001-06-01 15:57:31 +00:00
itojun
317eb9acd4
compile without INET6. PR 13080
2001-06-01 15:49:53 +00:00
thorpej
356699e86b
Fat-trimming.
2001-06-01 15:30:11 +00:00
thorpej
c702830c42
The P-4032 has no ISA bridge/bus, so remove all P-4032 conditionals.
2001-06-01 15:20:06 +00:00
toshii
07187f8a43
Nuke FRAMEBUF_HW_BASE. This value is provided by the bootloader.
2001-06-01 14:08:35 +00:00
toshii
6349d0ae81
Nuke FRAMEBUF_{HW_,}BASE. This hack does no good.
2001-06-01 14:06:43 +00:00
toshii
ea77ec5725
Move some low-level code (SVC mode switching and PID address translation
...
disabling) which was written using inlined asm in initarm() to just after
the kernel entry point.
2001-06-01 14:04:29 +00:00
tv
4909bd1ed2
Add (const char **) cast to some struct initializers to make the type-correct
...
(fixes warning in toplev.c). As far as the appropriate code is concerned in
toplev.c, these values are const; they're initialized exactly once beforehand.
2001-06-01 13:31:46 +00:00
haya
1331bcc296
cardbusvar.h is divided into two files: cardbusvar.h and cardbusreg.h.
2001-06-01 10:30:37 +00:00
bouyer
88f3192778
Fix typo in sddump() which caused core dumps to fail with ENXIO.
2001-06-01 08:39:54 +00:00
scw
78aad8f79e
Mark evcnt(9) item as done.
2001-06-01 08:31:07 +00:00
itojun
781f6920ab
use default hoplimit when incoming interface is not given to icmp6_reflect.
...
sync with kame
2001-06-01 05:54:19 +00:00
simonb
37326d639b
Rename assembly files that are pre-processed by cpp to use an S suffix.
2001-06-01 04:20:04 +00:00
thorpej
9f159a8918
Remove 4096-byte gap between .reginfo and .data, suggested by
...
Ian Taylor <ian@zembu.com>.
2001-06-01 03:55:30 +00:00
thorpej
f4f6c1dd1c
Enable SCSI.
2001-06-01 03:53:29 +00:00
toshii
76b3b49bb8
Add support for jornada720's framebuffer.
...
The functionality is almost same as bivideo, and hardware rasops and
power saving are not yet supported.
2001-06-01 02:51:03 +00:00
tv
ff53e0cd93
Add a cast for proper type conversion, which was causing a warning.
2001-06-01 02:42:26 +00:00
thorpej
53369113ed
Add SMC 9462.
2001-06-01 01:28:28 +00:00
simonb
b3e7ecfd97
Delete the XXX'd includes of <dev/isa/isavar.h> and <sys/kernel.h>.
...
These aren't needed. Tested on i386 and alpha.
2001-06-01 00:38:31 +00:00
tron
972b8c6bca
Readd "/usr/include/dev/scsipi/scsi_cd.h".
2001-05-31 21:56:23 +00:00
tron
264d7e1264
Install "dev/scsipi/scsipi_cd.h" again because it is e.g. used by the
...
CD player include in version 2.x of the "kdemultimedia" package.
2001-05-31 21:54:07 +00:00
gmcgarry
828e6159c7
- correctly describe the usage of flags to the lock manager
...
- clarify terminology on shared and exclusive access to locks
- fix history
- formatting fixes
2001-05-31 21:00:07 +00:00
soda
f57a0847d2
fix off by one error. extra one page is needed for the case where
...
buffer is not page aligned (e.g. raw i/o case).
2001-05-31 20:56:29 +00:00
thorpej
fc105c4392
Add nsphyter(4) and gphyter(4).
2001-05-31 20:49:42 +00:00
thorpej
532f86d0b0
Add nsphyter(4) and gphyter(4) manual pages.
2001-05-31 20:48:56 +00:00
thorpej
996df042df
Add support for the DP83815 MacPHYTER internal PHY to the DP83843 PHYTER
...
driver, since for our purposes, they are compatible.
2001-05-31 20:30:21 +00:00
soda
ea2e5754dd
missing opt_inet.h
2001-05-31 19:56:13 +00:00
tv
763e939509
Make all ELF platforms properly use -dynamic-linker, crt0, crtbegin, and
...
crtend, primarily for testing. Fixes bootstrap ld testsuite failures.
2001-05-31 19:48:58 +00:00
soda
9bac50748f
"opt_ddb.h" should be included at the beginning of source file,
...
because some headers (in this case <systm.h>) refers symbols (e.g. DDB)
defined in the opt_ddb.h
2001-05-31 19:41:57 +00:00
thorpej
1042f830e5
Regen; added several more PHYs.
2001-05-31 19:41:07 +00:00
thorpej
0c94166e28
Add several additional PHYs.
2001-05-31 19:40:33 +00:00
thorpej
f752c7d328
On the Gig PHYTER, For whatever reason, the 10baseT-related bits of the
...
BMSR are wired to 0, yet the PHY supports 10baseT. So, to get around
this, we test the ANAR 10baseT bits after a PHY reset. These bits are
set according to input pin 180. If we see the 10baseT ANAR bits set,
we fake them in the BMSR so that we can actually autonegotiate 10baseT.
2001-05-31 18:47:22 +00:00
scw
59ba4788ce
Deprecate intrcnt/intrnames in favour of the generic evcnt(9) interface.
2001-05-31 18:46:07 +00:00
thorpej
2128d9199a
Enable frobbing the 1000baseT control register on Gig-E PHYs,
...
used for hard-wiring master mode, and for advertising the 1000baseT
media options during autonegotiation.
2001-05-31 18:44:48 +00:00
tv
737585d43c
Merge from gnu/dist/gdb:
...
- Kill KERNEL_U_ADDR stuff, etc. [gwr]
- Provide a descriptive error message if "-k" is used. [gwr]
- Use NO_SOLIB to turn off inclusion of "solib.h". [msaitoh]
2001-05-31 17:08:54 +00:00
tv
9dd3a5f4b8
Add ignore case for N_WARNING [adapted from gwr].
2001-05-31 16:59:15 +00:00
tv
3fc4ebc16d
Remove dupe for sparc-netbsdaout (which will match anyway on sparc-netbsd*).
2001-05-31 16:50:04 +00:00
tv
d49ce936d5
Merge change from gnu/dist/gdb [jonathan]:
...
patch solib.c from gdb 4.16 to work around non-relocation and
misfeatures with ELF on mips. Without this, gdb gets addresess in
shared-libraries wrong and reports `heuristic fencepost' error.
(cf. the special-case solib functions duplicated in irix5-nat.c.)
tv: XXX this should be migrated to a MD file in the future.
2001-05-31 16:45:39 +00:00
tv
d582978a38
Re-add kcore support for i386.
2001-05-31 16:39:08 +00:00
thorpej
a6e732946b
Add an Ethernet option bit for master mode (for 1000baseTX, the link
...
master provides the clock -- this is normally the switch, but if you
are doing back-to-back NICs, you need to tell one side to be the master).
2001-05-31 16:30:04 +00:00
thorpej
628a67ab31
Add a driver for the NatSemi DP83891 and DP83861 Gig PHYTER
...
10/100/1000 PHYs.
2001-05-31 16:06:58 +00:00
thorpej
ea1aed7db2
Make the number of ticks between auto-negotiation tries PHY-specific,
...
and default every PHY to 5 seconds (what we used before). If we find
Gig-E media on a PHY, bump it to 10 seconds, since it can take 5
seconds just to negotiate a Gig-E link.
2001-05-31 16:02:29 +00:00
tv
3fe2119317
Use rs6000/xm-sysv4.h as the xm_file for powerpc (much closer to what we
...
really have than the default xm-rs6000.h).
2001-05-31 15:17:11 +00:00
tv
c482b60bca
Revert previous. The problem is generated by a wrong xm_file defining USG.
2001-05-31 15:15:46 +00:00
tv
d60682457b
Revert previous; this isn't where the problem is.
2001-05-31 15:07:05 +00:00
tv
b3161809b7
Turn off COFF support, as that's not the file format used by powerpc-netbsd.
...
(Causes problems compiling collect2 natively.)
2001-05-31 14:58:59 +00:00
ad
f4afeda420
Reduce the delay when polling so that dumps go faster.
2001-05-31 11:31:43 +00:00