Do not use a subshell to hide the shadowing of $config_host_mak.
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
While a simple lexicographic comparison usually works, it is less
robust than a more specific algorithm designed to compare versions.
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Add a 'current_lun' check for a null value
to avoid null pointer dereferencing and
recover host if NULL return
Found by Linux Verification Center (linuxtesting.org) with SVACE.
Fixes: 4eb8606560 (esp: store lun coming from the MESSAGE OUT phase)
Signed-off-by: Alexandra Diupina <adiupina@astralinux.ru>
Message-ID: <20231229152647.19699-1-adiupina@astralinux.ru>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The sgx_epc_get_section stub is reachable from cpu_x86_cpuid. It
should not assert, instead it should just return true just like
the "real" sgx_epc_get_section does when SGX is disabled.
Reported-by: Vladimír Beneš <vbenes@redhat.com>
Cc: qemu-stable@nongnu.org
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Message-ID: <20220201190941.106001-1-pbonzini@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The main difficulty here is that a page fault when writing to the destination
must not overwrite the flags. Therefore, the flags computation must be
inlined instead of using gen_jcc1*.
For simplicity, I am using an unconditional cmpxchg operation, that becomes
a NOP if the comparison fails.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
ALU instructions can write to both memory and flags. If the CC_SRC*
and CC_DST locations have been written already when a memory access
causes a fault, the value in CC_SRC* and CC_DST might be interpreted
with the wrong CC_OP (the one that is in effect before the instruction.
Besides just using the wrong result for the flags, something like
subtracting -1 can have disastrous effects if the current CC_OP is
CC_OP_EFLAGS: this is because QEMU does not expect bits outside the ALU
flags to be set in CC_SRC, and env->eflags can end up set to all-ones.
In the case of the attached testcase, this sets IOPL to 3 and would
cause an assertion failure if SUB is moved to the new decoder.
This mechanism is not really needed for BMI instructions, which can
only write to a register, but put it to use anyway for cleanliness.
In the case of BZHI, the code has to be modified slightly to ensure
that decode->cc_src is written, otherwise the new assertions trigger.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
gen_jcc() has been changed to accept a relative offset since the
new decoder was written. Adjust the J operand, which is meant
to be used with jump instructions such as gen_jcc(), to not
include the program counter and to not truncate the result, as
both operations are now performed by common code.
The result is that J is now the same as the I operand.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Similar to gen_setcc1, make gen_cmovcc1 receive TCGv. This is more friendly
to simultaneous implementation in the old and the new decoder.
A small wart is that s->T0 of CMOV is currently the *second* argument (which
would ordinarily be in T1). Therefore, the condition has to be inverted in
order to overwrite s->T0 with cpu_regs[reg] if the MOV is not performed.
This only applies to the old decoder, and this code will go away soon.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Do not use gen_op, and pull the load from the accumulator into
disas_insn.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Create a new temporary, to ease the register allocator's work.
Creation of the temporary is pushed into gen_ext_tl, which
also allows NULL as the first parameter now.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Just create a temporary for the occasion.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The new x86 decoder wants the gen_* functions to compute EFLAGS before
writeback, which can be an issue for instructions with a memory
destination such as ARPL or shifts.
Extract code to compute the EFLAGS without clobbering CC_SRC, in case
the memory write causes a fault. The flags writeback mechanism will
take care of copying the result to CC_SRC.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The new decoder would rather have the operand in T0 when expanding SCAS, rather
than use R_EAX directly as gen_scas currently does. This makes SCAS more similar
to CMP and SUB, in that CC_DST = T0 - T1.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The new decoder likes to compute the address in A0 very early, so the
gen_lea_v_seg in gen_pop_T0 would clobber the address of the memory
operand. Instead use T0 since it is already available and will be
overwritten immediately after.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
decode->mem is only used if one operand has has_ea == true. String
operations will not use decode->mem and will load A0 on their own, because
they are the only case of two memory operands in a single instruction.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Usually the registers are just moved into s->T0 without much care for
their operand size. However, in some cases we can get more efficient
code if the operand fetching logic syncs with the emission function
on what is nicer.
All the current uses are mostly demonstrative and only reduce the code
in the emission functions, because the instructions do not support
memory operands. However the logic is generic and applies to several
more instructions such as MOVSXD (aka movslq), one-byte shift
instructions, multiplications, XLAT, and indirect calls/jumps.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
X86_SPECIAL_ZExtOp0 and X86_SPECIAL_ZExtOp2 are poorly named; they are a hack
that is needed by scalar insertion and extraction instructions, and not really
related to zero extension: for PEXTR the zero extension is done by the generation
functions, for PINSR the high bits are not used at all and in fact are *not*
filled with zeroes when loaded into s->T1.
Rename the values to match the effect described in the manual, and explain
better in the comments.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Use _tl operations for 32-bit operands on 32-bit targets, and only go
through trunc and extu ops for 64-bit targets. While the trunc/ext
ops should be pretty much free after optimization, the optimizer also
does not like having the same temporary used in multiple EBBs.
Therefore it is nicer to not use tmpN* unless necessary.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The previous check erroneously allowed CMP to be modified with LOCK.
Instead, tag explicitly the instructions that do support LOCK.
Acked-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
cpu_cc_compute_all() has an argument that is always equal to CC_OP for historical
reasons (dating back to commit a7812ae412, "TCG variable type checking.", 2008-11-17,
which added the argument to helper_cc_compute_all). It does not make sense for the
argument to have any other value, so remove it and clean up some lines that are not
too long anymore.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
gen_lea_v_seg (called by gen_add_A0_ds_seg) already zeroes any
bits of s->A0 beyond s->aflag. It does so before summing the
segment base and, if not in 64-bit mode, also after summing it.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
is_int is always 1, and error_code is always zero.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
OF is equal to the carry flag, so use the same CCPrepare.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Take advantage of the fact that there can be no 1 bits between SF and OF.
If they were adjacent, you could sum SF and get a carry only if SF was
already set. Then the value of OF in the sum is the XOR of OF itself,
the carry (which is SF) and 0 (the value of the OF bit in the addend):
this is OF^SF exactly.
Because OF and SF are not adjacent, just place more 1 bits to the
left so that the carry propagates, which means summing CC_O - CC_S.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Reviewed-by: Juan Quintela <quintela@redhat.com>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20231221031652.119827-72-richard.henderson@linaro.org>
While const data in tests is not particularly important,
this makes a grep test clear across the tree.
Reviewed-by: Juan Quintela <quintela@redhat.com>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20231221031652.119827-71-richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20231221031652.119827-70-richard.henderson@linaro.org>
Tested-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20231221031652.119827-68-richard.henderson@linaro.org>
Reviewed-by: Juan Quintela <quintela@redhat.com>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20231221031652.119827-67-richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Zhao Liu <zhao1.liu@intel.com>
Message-Id: <20231221031652.119827-66-richard.henderson@linaro.org>
Tested-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20231221031652.119827-54-richard.henderson@linaro.org>
Tested-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20231221031652.119827-53-richard.henderson@linaro.org>
