1) Don't wait for DRQ on an IDENTIFY command -- if it's not set when we see
BSY clear, abort the command and ignore the drive. (Do this by testing
for DRQ in the read/write cases in __wdccommand_intr().)
2) Don't wait for DRQ to deassert when we finish an IDENTIFY (or any other
non-block command that reads data) -- we don't do this for block I/O, and
empirically it doesn't clear on my CF cards at all, causing a pointless 1s
delay.
3) Add comments to some of the delay()s, and add missing ones in wdcreset()
and the WDCC_RECAL in the so-called "pre-ATA" probe.
4) Slightly simplify the reset sequence -- we were doing an extra I/O.
5) Modify the register writability test to make sure that registers are not
overlapped -- this can happen in some weird cases with a missing device 1.
6) Check the error register value after the reset -- if it's not 01h or 81h,
as appropriate (see ATA spec), punt.
Tested with a number of ATA-only, ATAPI-only, mixed ATA-ATAPI, CF, and IDE
disk configurations.
Also remove the SINGLE_DRIVE nonsense again.
most polling.
2) Clean up some goofiness in pciide -- get rid of the whole "candisable" path
(it's gratuitous) and simplify the code by calling pciide_map_compat_intr(),
*_set_modes() and wdc_print_modes() from central locations.
3) Add a register writability and register ghost test to eliminate phantom
drives more quickly.
PCIC_VENDOR_NONE: New.
PCIC_VENDOR_CIRRUS_*: Collapse the 2 chips into one vendor ID.
pcic_ident_ok(): Check the ID revision field -- if it's 0, punt.
pcic_vendor(): Check the ID revision field -- if it's 0, or the ID register
is all-1s, assume there is no chip present. (Previously this would return
"Unknown controller" -- which, AFAICT, *never* resulted in a working device.)
Do the Cirrus check only after verifying that we got the Intel ID.
pcic_attach(): Use a priori knowledge of the Cirrus chips to determine the
number of sockets rather than trying (unsuccessfully) to probe. Also, just
blast all of PCIC_INTR -- we do this in pcic_deactivate_card() anyway.
be inserted into ktrace records. The general change has been to replace
"struct proc *" with "struct lwp *" in various function prototypes, pass
the lwp through and use l_proc to get the process pointer when needed.
Bump the kernel rev up to 1.6V
isa_dmamap_create() calls to their open/close entrypoints. This worked
with some luck, but broke on i386 when _bus_dmamap_create started
to allocate bounce buffers upfront, since memory below 16M may well
not be available when the sound devices is opened for the Nth time.
To fix this, create a new simple interface, isa_drq_alloc/isa_drq_free,
wrappers around already existing bitmask macros. These are expected
to be used before an isa_dmamap_create call, and after an
isa_dmamap_destroy call, respectively. For the sb and ad1848 drivers,
they're deferred until open/close.
All isa_dmamap_create calls can now use BUS_DMA_ALLOCNOW and be done
at attach time.
malloc types into a structure, a pointer to which is passed around,
instead of an int constant. Allow the limit to be adjusted when the
malloc type is defined, or with a function call, as suggested by
Jonathan Stone.
