1. size_t is 64 bits, so use a u_32_t for iplused
2. microtime() and friends expect a struct timeval,
passing the first of two unsigned longs will not cut it.
as necessary:
* Implement a new mbuf utility routine, m_copyup(), is is like
m_pullup(), except that it always prepends and copies, rather
than only doing so if the desired length is larger than m->m_len.
m_copyup() also allows an offset into the destination mbuf, which
allows space for packet headers, in the forwarding case.
* Add *_HDR_ALIGNED_P() macros for IP, IPv6, ICMP, and IGMP. These
macros expand to 1 if __NO_STRICT_ALIGNMENT is defined, so that
architectures which do not have strict alignment constraints don't
pay for the test or visit the new align-if-needed path.
* Use the new macros to check if a header needs to be aligned, or to
assert that it already is, as appropriate.
Note: This code is still somewhat experimental. However, the new
code path won't be visited if individual device drivers continue
to guarantee that packets are delivered to layer 3 already properly
aligned (which are rules that are already in use).
to enable 64-bit data transfers on 64-bit cards when plugged into
a 64-bit slot. Right know the Asante GigaNIX is listed in that
table.
Sigh, there is an EEPROM bit that can be used to detect 64-bit vs
32-bit cards. Unfortunately, at least 2 vendors of 32-bit cards
fail to clear the "DATA64_EN" bit in the EEPROM, which causes the
card to lose badly, because it still manages to detect that it's
plugged into a 64-bit PCI slot. Yay, stupid hardware vendors.
path: Instead of waiting for the if_snd queue to be drained before
giving ownership of the frist descriptor to the chip, do it after
sync'ing all the descriptors for a single packet.
* Get CFG_M64ADDR, CFG_T64ADDR, and CFG_DATA64_EN from the EEPROM.
Note, we still disable CFG_M64ADDR and CFG_T64ADDR later (XXX need
PCI bus capability flags for these).
* Print a message if we're in a 64-bit slot and 64-bit data is
disabled in the EEPROM. Make sure CFG_DATA64_EN is disabled if
we're not in a 64-bit slot.
sysconf(_SC_CLK_TCK) return hz will work.
In detail:
__times13() returns values scaled by hz.
times() returns values scaled by 100.
<sys/times.h> renames times() to __times13().
_SC_CLK_TCK has changed from 3 to 39.
sysconf(3) returns 100.
sysconf(39) returns hz.
CLK_TCK is defined as sysconf(39).
mount point was specified, make sure to add only a commented-out entry for
that partition when building fstab. This prevents sysinst from generating
an otherwise invalid fstab. This problem was originally reported by
Frederick Bruckman and fixed by Bob Nestor.
cpus and hz is measured in ticks per cpu, divide tick count by ncpu to
determine elapsed time since last sample.
Fixes I/O rate deflation observed on multiprocessors.
christos