"If a channel has no drives, do *not* unmap its I/O regions.
It's not really safe to use them for anything else, and in legacy mode it
will just cause us to probe the channel again as an ISA device."
- keep the modes supported by the drive in struct ata_drive_datas (will be
later used for downgrading the DMA/PIO mode on error)
- use config flags to force/disable PIO/DMA/UDMA modes
- For the CMD PCI0643/6 setup DMA mode to DMA Read multiple.
eg the Cypress ISA bridge:
-put channel mapping into the chip specific part, unify with
channel_probe() into channel_map()
-use pointer to channel data as function call argument wherever possible
instead of the channel number
-allow the "compat" channel number to differ from the per-controller
channel number - for mapping and interrupt functions
-add support for SiS5598 and Cypress 82C693 chips
Mostly done by Manuel, I only contributed to the first 2 items.
Don't claim DMA support if we don't have explicit support for this chip.
They're to may way to loose when trying to use DMA without configuring the
controller and disks.
in the printing of DMA mode (piix3/4 only)
others: set the debug_mask to 0, so that debug messages are turned off by
default but can be easily turned on.
Reset drive_flags to 0 for unconfigured devices, so that they are ignored
later. For configured devices, reset state to 0 after probe/attach.
if i drive is responding):
-if the reset succeeds, check some registers to make sure there is really
a drive (and not a chipset which echoes back the last written value)
-explicitely select the master before trying to read the master's status
and see if anything responds. if nothing (that's attributable to the
PCI IDE controller) responds, then that channel either has no devices on
it or has been disabled (via a non-standard mechanism) by the BIOS. If nothing
responds, don't map the compat.-mode interrupt or attach the wdc to that
channel, because the BIOS is likely to assign that IRQ to a different PCI
device. If that happens, the kernel will panic because that device will
try to map the IRQ level-triggered, but the compat interrupt will have been
mapped edge-triggered. (One possible way around this is to map the compat
interrupt edge-triggered, but it's not clear reading the spec that this
is correct or desirable.)
insert a check to see whether a channel appears to be enabled. Shouldn't
be necessary, according to the spec, but some PC chipsets allow individual
compatibility channels to be disabled. "I hate PCs."
bouyer