and shares some bits with ISA AT1700 driver. Gee, this one was really
easy :)
This card turned out to be quite good performer - I get about 360KB/s
on 386DX PS/2 machine, which is best of all supported cards so far.
and use appropriately
- create more helper macros:
. cdev__xyz_init(c,n), such as cdev__ocri_init() for
/* open, close, read, ioctl */, etc.
. cdev__xRy_init(c,n), where nullop is used instead of enodev to dummy out
method `R' and the comments now read /* xxx (read) yyy */ instead
. cdev__xyz_t_init(c,n,t) - as per cdev__xyz_init, but sets d_type = t
as well
- use seltrue instead of dev_noimpl(poll,*), as (IIRC) cdevsw.d_poll should
always DTRT WRT returning a valid result. (a few devices previously
incorrectly returned ENODEV)
- use dev_noimpl(stop,enodev) instead of dev_noimpl(stop,nullop) if tty
== 0, because it doesn't matter if dev_type_stop isn't implemented in that
case, and it allows the use of the cdev__xyz_init macros. certain ports
(sparc,sparc64,x68k) used the nullop method for dev_type_stop in a few
drivers, whereas everything else uses enodev
- ensure that the comments are accurate WRT the behaviour of a given entry
they keep giving error 0x30b. Unfortunately this keeps happening every second
making the console unusable. Keep track of the last error that occurred and
if the last 10 times apm was called the same error was returned, give up and
exit the apm thread.
WD8003W/A, card provided by David Brownlee (thanks!). The SMC Elite stuff not
tested since I don't have any; hopefully it's correct, should match
information in ADF files.
The MCA-specific init quirk taken from Linux smc-mca.c driver.
I don't quite grok why it works, but it does *cross fingers*.
The WD8003W/A seems to be quite a good choice. I get like 340KB/s on my
machine, where 3c523 does only like 310KB/s. The numbers would be probably
even better with faster CPU than 386DX :)
provided to me by David Brownlee (thanks!).
Performance of this card is quite poor on my PS/2 with 386DX, like 100KB/s
at best, but as low as 5KB/s when transferring bigger files due to
packet overruns. It would be good to revisit this later, probably by
teaching the ic code to use RX Early.
of uvm_fault() to the onfault routine via %eax. users of pcb_onfault now
return this value to their callers rather than always returning EFAULT.
this allows i/o errors in VOP_GETPAGES() to be returned back to read(), etc.
Remove duplicate prototype for i386_{set,get}_ldt() from sys_machdep.c.
Change i386_iopl() and i386_{set,get}_{ldt,ioperm}() to take a second
argument of "void *" instead of "char *", for consistency with other syscalls.
thorpej