without MII. It supports 100BaseTX only. Half duplex/Full duplex can
be specified manually, but there are no auto negotiation functionality.
XXX: It takes 34 seconds before sending/receiving packets on the wire
after initial setup. It is obviously a bug because the board
just works fine on NEWS-OS, but I cannot find what's wrong...
Once it starts working, it seems there are no problems.
for each driver to indicate the interrupt has been handled or not.
add prototype of apbus_dmatag_init() function, which allocates memory
and initialize its member including bus space handle to flush DMA write
cache. Note that the allocated pointer must be freed.
Clear interrupt mask for specified interrupt in apbus_intr_establish().
Add dma stuff; define apbus_dmamap_sync() to flush DMA write cache by
accessing the corresponding I/O port.
does nothing useful at this moment - initailize the chip, that's all.
TODO: crypto logic framework in kernel (see openbsd sys/crypto)
TODO: ipsec frontend (need major rework in ipsec tree - should start with busywait)
TODO: character device frontend
seperate booleans. Add flags to run as a plain 'system()' command,
fullscreen (but on a pty), and chrooted, and implement their
functionality. Add a bit of TIOCPKT handling code to handle
programs messing with term settings better.
* Ask to set the root password at the end of an install.
* Remove a few unneeded comments.
* Sprinkle some touchwin() calls here and there to make the output cleaner.
They shouldn't really be needed, but even normal usage (no syslog
messages) even left the screen messy sometimes.
* Change some messages around that were apparently swapped by accident and
thus caused confusion.
for the disklabel if the given device fails with EBUSY. Also make disklabel
errors non fatal (just fall back to ffs as per pre-autofilesystem behaviour)
Based on further discussion with Launey Thomas <ljt@alum.mit.edu>
it and free it as appropriate. Activate p2's new address space once
it references p1's.
- uvm_fork(): Make sure the child's vmspace is NULL before calling
uvmspace_share() (the child doens't have one already in this case).
These changes do not change the behavior for the current use of
uvmspace_share() (vfork(2)), but make it possible for an already
running process (such as a kernel thread) to properly attach to
another process's address space.
to the contents of the hint in the map, and the hint saved in the
map only if the two values match. When an unconditional save is
required, the "check" value passed should be map->hint (and the
compiler will optimize the test away). When deleting a map entry,
the new SAVE_HINT() will only change the hint if the entry being
deleted was the hint value (thus preserving any meaningful hint
that may have been there previously, rather than stomping on it).
- Add a missing hint update when deleting the map entry in
uvm_map_entry_unlink(). This is the fix for kern/11125, from
ITOH Yasufumi <itohy@netbsd.org>.
TULIPF_BLE /* data is big endian */
TULIPF_DBO /* descriptor is big endian */
These setting is required for Big-endian bus front-end (such as APbus for
newsmips) to work with tulip. Also,
sc_maxburst
member is added to the tulip_softc to limit the maximum burst length.
This member defaults to zero which means no restriction for burst length.
onoe