it from the QuickLogic chip version byte.
If found, switch it to non-autorepeat mode (which seems to avoid the race
condition which made my keyboard driver / X server lose state under heavy
interupt load).
If not found, assume an Amiga keyboard on CIA-A.
XXX We should probe for the presence of the CIAs on the DraCo.
We play mono samples on all 4 channels.
However, we get the volume settings for mono samples as a symmetic two-channel
setting... the other two channels used to stay at max volume...
I believe that something else is wrong here, but dont want to change MI
code (which in turn influences a couple of MD driver) thus late in the release
cycle.
- use board address space > 4 MB, instead of iszthreepa(), to detect Z3-mode
boards. We dont want the bus, but want the address configuration.
- s/CV64CONSOLE/CV3DCONSOLE/
- s/cv3d_zorroIII == 1/cv3d_zorroIII/ and s/cv3d_zorroIII != 1/!cv3d_zorroIII/
the CyberVision64 driver. Modified by Tobias Abt with some bugfixes
from Bernd Ernesti.
ZorroII is at the moment not supported and there is a small problem
with the Console driver where you just get a black screen, but the
system boots and you can use X11 without a problem.
The changes is to allow some limited mixer manipulation through
the audio device (instead of the mixer device).
This rendered 4 methods in audio_hw_if unused so garbage collect these.
This will be used by certain SCSI drivers to limit the length of DMA transfers
when the serial port is running at higher speeds. GVP and Phase5 DMA
interfers significantly with CPU execution, and significantly increases
receive buffer overruns (silo overflow). Reducing the DMA transfer length
can reduce the overruns.
NOTE: due to hardware requirement of the AGA chipset, the framebuffer width
has to be a multiple of 64 bits. An 800x600 display will use a memory width
of 832 bits, which the current X server can't handle. To get a usable
display, the width needs to be 832 or 768.
* support chip clocks != COM_FREQ, by introducing sc_frequency (for the
mainline code) and adding a frequency parameter right after the rate
parameter to comcnattach() and com_kgdb_attach().
- Make com_isa and com_multi initialize sc_frequency to COM_FREQ.
- Make i386/machdep.c and alpha/dec_xxx.c call com*attach() with the freq.
parameter.
* supio_attach_args get two more fields: a sc_ipl and a sc_arg, both ints.
- com_supio uses the first for interupt establishment (all childs will, as
soon as they exist) and the 2nd for sc_frequency.
- drsupio passes sc_ipl alway as 5, and for the "com"s, sc_arg as 16*115200
- hyper will pass sc_ipl as 6, and sc_arg as 16 * 460800
