current ifmedia_entry, not from the user-supplied media word. The
user supplied media word may not necessarily match e.g. instance (if
the parent MAC driver is intentionally ignoring instance if its expecting
multiple PHYs with non-overlapping media, e.g. TI ThunderLAN) the media
word we are actually switching to.
Since PHY drivers use `instance' to determine if they should isolate
themselves, the ThunderLAN PHY was sometimes being incorrectly isolated
when in fact the user attempted to select that PHY (for e.g. BNC operation).
that we may have (TLPHY_MEDIA_10_x | TLPHY_MEDIA_NO_10_T).
- add carrier detect for AUI/BNC.
This now works properly with a "Compaq Netelligent 10/100 TX" and a
"Compaq ProLiant Integrated Netelligent 10/100 TX", untested with others
(but should work as well).
properly! Work around this by determing current active media by taking
the highest-order common bit of our advertised capabilites and the link
partner's.
If the link partner doens't do autonegotiation, then parallel detection will
pick up the media type, which will never be full-duplex, so reading the PAR
is ok in this case.
Bug pointed out by Matthias Drochner, work-around inspired by reading
the dp83840 manual, section 3.9 (IEEE 802.3u auto-negotiation).
802.3u autonegotiation, and will report the precise media selected
by autonegotiation by reading PHY-specific registers.
XXX There is still some work to do wrt. autonegotiation and the
BNC/AUI support in the ThunderLAN PHY.
as with user-land programs, include files are installed by each directory
in the tree that has includes to install. (This allows more flexibility
as to what gets installed, makes 'partial installs' easier, and gives us
more options as to which machines' includes get installed at any given
time.) The old SYS_INCLUDES={symlinks,copies} behaviours are _both_
still supported, though at least one bug in the 'symlinks' case is
fixed by this change. Include files can't be build before installation,
so directories that have includes as targets (e.g. dev/pci) have to move
those targets into a different Makefile.
in pci/if_tl.c, call config_found() with a print function, instead of
printing ourself a message in if_tl.c if no miibus was found. The print
function is in mii/mii.c (mii_adapter_print()) so that it can be used by any
adapter (idea from the scsi system).
adapters, and provide media-selections and status to the parent.
This includes drivers for the Thunderland integrated PHY, and
National Semiconductor's DP83840A.
Note: The interface betweeen network controller and mii is not complete yet,
and will need some minors tweaks to support media auto-selection.
