> 2000-03-06 Clinton Popetz <cpopetz@cygnus.com>
>
> * config/sh/sh.c: (barrier_align): Handle a delay slot that is
> filled with an insn from the jump target.
> Fix pcrel too far problems due to upping CACHE_LOG on SH2:
> * sh.c (barrier_align): Don't return early for normal branch/barrier
> when optimizing for SH2.
Significant cleanup, here, including better PTE bit names.
* Add XScale PTE extensions (ECC enable, write-allocate cache mode).
* Mechanical changes everywhere else to update for new pte.h. While
doing this, two bugs (as a result of typos) were fixed in
arm/arm32/bus_dma.c
evbarm/integrator/int_bus_dma.c
> 2000-09-19 Bernd Schmidt <bernds@redhat.co.uk>
>
> * final.c (insn_current_reference_address): Use INSN_SHUID of seq
> rather than that of branch.
> (shorten_branches): Don't increment insn_current_address twice.
> Wed Feb 23 16:42:21 2000 J"orn Rennecke <amylaar@cygnus.co.uk>
>
> * final.c (shorten_branches): Make value passed to LOOP_ALIGN
> conform to documentation.
the interface was wired to full-duplex mode. Duh.
Also, add OPMODE_TTM to OPMODE_MEDIA_BITS, to insure that it is changed when
we switch between 10 and 100.
ticks over at half the CPU clock speed, and set this flag for the known
CPUs with this behaviour. Better names for this flag gratefully accepted!
Also adjust comment about known R4000/R4400 revisions.
to be trying to wriggle out of supporting this well. Instead, use
GID_FT to get a list of Port IDs and then use GPN_ID/GNN_ID to find the
port and node wwn. This should make working on fabrics a bit cleaner and
more stable.
This also caused some cleanup of SNS subcommand canonicalization so that
we can actually check for FS_ACC and FS_RJT, and if we get an FS_RJT,
print out the reason and explanation codes.
We'll keep the old GA_NXT method around if people want to uncomment a
controlling definition in ispvar.h.
This also had us clean up ISPASYNC_FABRICDEV to use a local lportdb argument
and to have the caller explicitly say that a device is at the end of the
fabric list.
The ICH on-board Ethernet and some i82559 chips have a bug which
will cause a PCI protocol violation if the chip receives a CU_RESUME
command as it is entering the IDLE state by deasserting #CLKRUN.
(This is the so-called "resume bug" that we previously had an incomplete
work-around for on ICH chipsets.)
The work-around is to disable Dynamic Standby Mode, such that the
chip will never deasert #CLKRUN. Dynamic Standby Mode is disabled
by clearing a bit in the EEPROM and updating the EEPROM (and EEPROM
checksum).
Unfortunately, the chip will only consult the EEPROM setting after
a PCI bus reset, so a system reboot is required once the EEPROM
has been updated (the EEPROM update only needs to happen once,
and the driver usses a warning instructing the user to reboot the
system once the work-around has been applied).
Issue pointed out by David Brownlee, and code more-or-less lifted
from FreeBSD.
