Earlier, we re-complained about excessive token losses about once a minute.
However, on small ARCnet networks, the token will also be lost if only one
station (us) is active (ifconfig'd down interfaces don't take place in the
token exchange), and our syslog would be filled with repeated messages about
this condition.
Our new code only complains once, starts a timeout() each time a token
regeneration is reported by the chip, and generates a log message about
the regenerated token if it was stable for 15 seconds.
buffer out of the hardware (it is invalid!).
This fixes hangups due to spurious rx interupts.
XXX Maybe I should completely reset the hardware in this case?
We test this condition AFTER the interupt condition, because it is only
disabled during autoconfiguration.
Without this patch, if autoconfiguration takes long enough, eventually a
timer interupt will call hardclock() and panic the machine.
Still untested on -1260/-1230, and hangs when enforcing SFAS_NO_DMA on 2060;
but works with DMA on the latter.
Still untested in a NetBSD-12A environment. (Sorry, don't have the hardware
myself.)
Thanks to Laurent Baroukh for being the guinea pig, and to Jerome Lovy
for forwarding the hardware information Phase V gave him, and to Phase
V for providing it.
Check only the IR bit of the CIAA Interrupt Control Register when testing
for a level 6 interrupt. An interrupt only occurs if IR is set, and IR is
only set if the individual mask bits are set. The individual interrupt
status bits can be set without causing an interrupt if the corresponding
enable bits are not set.
clock_attach() time (for now).
This removes our dependance on the DraCo ROM access timing and frees
the second CIA on Amigas.
b) support for DraCo rev. >= 4 native timer chips.
for a level 6 interrupt. An interrupt only occurs if IR is set, and IR is
only set if the individual mask bits are set. The individual interrupt
status bits can be set without causing an interrupt if the corresponding
enable bits are not set.
"The mapping of IP Class D addresses to local addresses is
currently specified for the following types of networks:
[...]
o Any network that supports broadcast but not multicast,
addressing: all IP Class D addresses map to the local
broadcast address."
