and link it directly to db_command_table[] so that it's not necessary
to do this at runtime. Make db_machine_command_table[] const on all ports.
g/c now unneded stuff, like db_machine_commands_install(), db_machine_init()
Patch written by enami.
at tcds in files.alpha for now, and add a new `xasc at tcds' to files.pmax.
after pmax has moved fully to MI scsi (and `asc' is MI scsi), we should move
the device asc, etc., lines to files.tc.
rather than assigning to the whole field, set or clear individual flags,
which implies that the B_BUSY and B_INVAL flags will remain set.
this allows us to make the assertion in brelse() that B_BUSY is set,
which is the purpose of all this.
16 bit sun checksum. This flag is needed when making iso 9660 images which
are bootable on both sparc and pmax machines.
this addresses PR port-pmax/10929
pseudo-device pty 2 # pseudo-terminals (Sysinst needs two)
(Some installers may not be using sysinst, in which case this just reduces
the number of ptys from 16 that are not used to 2 that are not used)
For i386 conf files, no change other than comments.
can not cross a page boundary. This fixes a problem when a dump(8) buffer
just crossed a page boundary and bus_dmamap_load() would coalesce the
the overlap onto the first segment. The NEXTPTR value would get set to
-1 when starting the DMA transfer and the residual data for unaligned
transfers would be copied to physical address 0x1ffffffc. On the R3000,
this would result in corrupted data, and on the R4000 would usually result
in a hard system hang.
both the primary and the secondary caches. MachFlushDCache() will not
invalidate the correct secondary cache lines for KSEG2 addresses.
R4000 systems should now be able to boot and run.
based on it working already for macppc.
Also add commented out:
#options VNODE_OP_NOINLINE # Don't inline vnode op calls
#options NFS_V2_ONLY # Exclude NFS3 and NQNFS code
as suggestions for additional savings
maps standard boot flags to corresponding RB_* values
use BOOT_FLAG() in port's MD code as appropriate
as discussed on tech-kern, add new boot flags -v, -q for booting
verbosely or quietly, and corresponding AB_VERBOSE/AB_QUIET
boot flags; also add FreeBSD-compatible bootverbose macro and
NetBSD-specific bootquiet macro
for hpcmips, use new bootverbose instead of it's own hpcmips_verbose
Tested on i386, and to limited extend (compile of affected files) also for
mvme68k, hp300, luna68k, sun3.
