Let's keep it very simple for now and flush the complete tlb,
we currently can't find the right entries in our tlb, we would have
to store the used tables for each element.
As we now fully implement the DAT-enhancement facility, we can allow to
enable it for the qemu CPU model.
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170622094151.28633-4-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
If only the page index is set, most likely we don't have a valid
virtual address. Let's do a full tlb flush for that case.
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170622094151.28633-3-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Let's allow to enable it for the qemu cpu model and correctly emulate
it.
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170622094151.28633-2-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Most of the PSW bits that were being copied into TB->flags
are not relevant to translation. Removing those that are
unnecessary reduces the amount of translation required.
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Missed the proper alignment in TRTO/TRTT, and ignoring the M3
field for all TRXX insns without ETF2-ENH.
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
This facility bit includes execution-hint, load-and-trap,
miscellaneous-instruction-extensions and processor-assist.
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
This facility bit includes load-on-condition-2 and
load-and-zero-rightmost-byte.
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
This facility bit includes DFP-rounding, FPR-GR-transfer,
FPS-sign-handling, and IEEE-exception-simulation. We do
support all of these.
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
This adds support for the MOVE WITH OPTIONAL SPECIFICATIONS (MVCOS)
instruction. Allow to enable it for the qemu cpu model using
qemu-system-s390x ... -cpu qemu,mvcos=on ...
This allows to boot linux kernel that uses it for uacccess.
We are missing (as for most other part) low address protection checks,
PSW key / storage key checks and support for AR-mode.
We fake an ADDRESSING exception when called from problem state (which
seems to rely on PSW key checks to be in place) and if AR-mode is used.
user mode will always see a PRIVILEDGED exception.
This patch is based on an original patch by Miroslav Benes (thanks!).
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170614133819.18480-3-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Such shifts are usually used to easily extract the PSW KEY from the PSW
mask, so let's avoid the confusing offset of 4.
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Thomas Huth <thuth@redhat.com>
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170614133819.18480-2-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
The FAC_ names were placeholders prior to the introduction
of the current facility modeling.
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Exit to cpu loop so we reevaluate cpu_s390x_hw_interrupts.
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Let's properly expose the CPU type (machine-type number) via "STORE CPU
ID" and "STORE SUBSYSTEM INFORMATION".
As TCG emulates basic mode, the CPU identification number has the format
"Annnnn", whereby A is the CPU address, and n are parts of the CPU serial
number (0 for us for now).
A specification exception will be injected if the address is not aligned
to a double word. Low address protection will not be checked as
we're missing some more general support for that.
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170609133426.11447-3-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
We can tell from the program interrupt code, whether a program interrupt
has to forward the address in the PGM new PSW
(suppressing/terminated/completed) to point at the next instruction, or
if it is nullifying and the PSW address does not have to be incremented.
So let's not modify the PSW address outside of the injection path and
handle this internally. We just have to handle instruction length
auto detection if no valid instruction length can be provided.
This should fix various program interrupt injection paths, where the
PSW was not properly forwarded.
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170609142156.18767-3-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170609142156.18767-2-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
We have to make the address in the old PSW point at the next
instruction, as addressing exceptions are suppressing and not
nullifying.
I assume that there are a lot of other broken cases (as most instructions
we care about are suppressing) - all trigger_pgm_exception() specifying
and explicit number or ILEN_LATER look suspicious, however this is another
story that might require bigger changes (and I have to understand when
the address might already have been incremented first).
This is needed to make an upcoming kvm-unit-test work.
Reviewed-by: Thomas Huth <thuth@redhat.com>
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20170529121228.2789-1-david@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
The CDSG instruction requires a 16-byte alignement, as expressed in
the MO_ALIGN_16 passed to helper_atomic_cmpxchgo_be_mmu. In the non
parallel case, use check_alignment to enforce this.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170604202034.16615-4-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Use a common helper with PACK ASCII as the differences are limited to
the stride of the source operand.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-25-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
For that we need to make program_interrupt available to qemu-user.
Fortunately there is almost nothing to change as both kvm_enabled and
CONFIG_KVM evaluate to false in that case.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-22-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
As MVCL and MVCLE only differ by their operands, use a common
do_mvcl helper. Optimize it calling fast_memmove and fast_memset.
Correctly write back addresses. Check that r1 and r2/r3 registers
are even.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-21-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
adj_len_to_page doesn't return the correct result when the address
is already page aligned and the length is bigger than a page. Fix that.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-20-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
As CLCL and CLCLE mostly differ by their operands, use a common do_clcl
helper. Another difference is that CLCL is not interruptible.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-19-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
There are multiple issues with the COMPARE LOGICAL LONG EXTENDED
instruction:
- The test between the two operands is inverted, leading to an inversion
of the cc values 1 and 2.
- The address and length of an operand continue to be decreased after
reaching the end of this operand. These values are then wrong write
back to the registers.
- We should limit the amount of bytes to process, so that interrupts can
be served correctly.
At the same time rename dest into src1 and src into src3 to match the
operand names and make the code less confusing.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-18-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Improve fix_address to also handle the 24-bit mode. Rename fix_address
to wrap_address to better explain what is changed.
Replace the calls to get_address with x2 = 0 and b2 = 0 by
call to wrap_address, leading to the removal of this function. Rename
get_address_31fix into get_address.
Reviewed-by: Thomas Huth <thuth@redhat.com>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-15-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
These functions differ from COMPARE by generating an exception for a
QNaN input. Use the non quiet version of floatXX_compare.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-10-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
And at the same time make IPTE SMP aware.
Reviewed-by: Thomas Huth <thuth@redhat.com>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-Id: <20170531220129.27724-4-aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
