This is to make sure all ARM platforms will benefit from planned work on this
MMU/CPU code. The less code duplicated, the better.
Compile-tested for all supported ARM platforms
* gPeripheralBase keeps track of the device
peripherals before and after mmu_init
* Add ability to disable mmu for troubleshooting
* Remove static FB_BASE, we actually don't know
where the FB is yet. (depends on firmware used)
* BCM2708 defines no longer assume 0x20 address
We will be throwing away the blob memory mapping
and using our own.
* Use existing blob mapping to turn GPIO led on pre mmu_init
* Remap MMU hardware addresses from 0x7E. We could map each device,
however the kernel will throw away the mappings again anyway. For
now we just map the whole range and use offsets.
* Serial uart no longer works, however at least
we know why now :). Serial driver now needs to
use mapped address.
* Use U-Boot mmu code as base
* This will be factored out someday into common arch mmu
code when we can read Flattened Device Trees
* Move mmu_init after serial_init.
Temporary change as we will want serial_init to use
memory mapped addresses... for debugging.
