- Add support for DT transfers (aka Ultra/160) in esiop
Note that DT transfers are not enabled for 53c1010-33 rev 0 yet; if I trust
FreeBSD it has a bug which prevent them to do DT properly.
From the same source there may be issues with some revs of 53c1010-66.
'command slots' in which the host can put command and wait for the script
to start them
- Change siop.c to do full disconnect/reslelect, allowing as much as one
command per target/lun to run in parallel.
- Fix bug in registers init where a board without BIOS would end at
ID 0 (now the driver works on alpha too).
- better handling of messages, sending back a MSG_EXT_SDTR in response to an
incoming MSG_EXT_SDTR, and MSG_MESSAGE_REJECT for unhandled messages.
- fix use of bus_dmamap_sync() and htole32().
- supports shared interrups
- change some int8 and int16 to int, for alpha and mips benefits ( suggested by
Toru Nishimura)
(the name 'siop' is still being discussed, may change).
Only basic disconnect/reselect for now, no sync/wide negotiation.
Tested with 810A, 875 and 895 on i386 only.
The bus-independant part should also be able to handle the 53c720 and 53c770.
A new driver with enhanced script should appear for the 825/875/895 'soon'.
