but the registers actually begin at 0x3f2, and this is what PNPBIOS reports
for the floppy controller resources. Adjust the register offsets and the
mapping of them for the ISA front-end to compensate, so that the PNPBIOS
attachment of the floppy controller actually works.
- Use proper CARDBUS_* macro in if_rl_cardbus.c
- Use product ID read from PCI configuration space rather than from EEPROM
in if_rl_pci.c.
Patch sent from Masanori Kanaoka <kanaoka@ann.hi-ho.ne.jp> and
some cosmetic changes by me.
Fix minor glitches.
Add preliminary support for ASB-3940U3W host adapters; it might work w/ autotermination on.
ASB-3940U3W support is not yet tested due to lack of board.
current attribute, but has all non-color flags turned off. Use this when
doing erasure, as this allows us to optimize repainting in curses.
XXX The way the default attribute is handled is totally bogus and needs to
be fixed.
Contrary to what the rtl8019 docs say, this seems to be necessary.
Observed by myself when implementing non-auto earlier, and independently
complained about by Antti Kante in PR 9962.
- Call bus_dmamap_sync(9) as appropriate.
- Leave only register declarations in rtl81x9reg.h and
split other stuff into rtl81x9var.h.
bus_dma(9) code mostly taken from thorpej's if_rtp.c.
'command slots' in which the host can put command and wait for the script
to start them
- Change siop.c to do full disconnect/reslelect, allowing as much as one
command per target/lun to run in parallel.
- Fix bug in registers init where a board without BIOS would end at
ID 0 (now the driver works on alpha too).
- better handling of messages, sending back a MSG_EXT_SDTR in response to an
incoming MSG_EXT_SDTR, and MSG_MESSAGE_REJECT for unhandled messages.
- fix use of bus_dmamap_sync() and htole32().
- supports shared interrups
- change some int8 and int16 to int, for alpha and mips benefits ( suggested by
Toru Nishimura)
- Use le32toh() on reading rxstat from the Rx DMA buffer.
- rl_read_eeprom() should return EEPROM values in little endian
when caller requires byte-stream data.
bus_dma(9) fixes are still on-going.
XXX rtk on macppc seems to make tons of CRC errors...
XXX Does it work fine on i386 or others?
augustss