address against our station address if it's not a multicast packet. Either
the Rhine manual lies about the phys/broadcast/multicast rxstatus bits,
or the Rhine chip is just broken.
Fixes a redirect storm problem reported by Laine Stump on current-users.
* Don't allocate receive buffers until the interface is actually brought
up, and release all of them if the interface is taken down.
* Add a knob (defaults to off) which will copy an incoming packet to
a single header mbuf if it is small enough to fit in one, rather than
burning an entire cluster on it. Note that this change will be mostly
moot if/when sbcompress() it changed to handle compressing clusters.
directly, call the function pointer (*if_input)(ifp, m). The input routine
expects the packet header to be at the head of the packet, and will adjust
as necessary. Privatize the layer 2 input and output routines, allowing
*_ifattach() to set them up as appropriate.
like the SMC83C100 EPIC/100 driver:
* Rather than using pointers to the head and tail of the transmit and
receive rings, use wrapping indexes into arrays. This is a little more
obvious when reading the code.
* More cleanly separate the hardware descriptor from the software descriptor.
* bus_dma it everywhere.
* Implement interrupt pacing and avoid a potential race in the transmit
loop.
Now this looks more or less like the Rhine driver I was working on when
this driver was committed :-) Update copyright notice to reflect that.
has the same 4-byte alignment requirement that the transmit side does. This
causes the packet payload to be misaligned. So, on systems which require
strict alignment, we must copy the incoming frame to a new packet buffer,
suitably aligned.
thorpej