zero. We use this later when the COMPLETE message comes in to set the
final residual count to zero. The flag is reset if the target resumes
a data phase. This obsoletes the `AUTOSAVE' quirk (for this driver).
Also, avoid overwriting the residual count if a SENSE was appended to
the current transaction.
renamed AUDIO_ENCODING_SLINEAR and AUDIO_ENCODING_LINEAR reverts to the
NetBSD 1.2 sematics. A kernel with COMPAT_12 defined will accept
AUDIO_ENCODING_LINEAR and treat it as before, without COMPAT_12 it
will be rejected.
'inline' as well as static. mark prototypes for static inline functions
as possibly unused (with __attribute__ ((unused))), to avoid generating
warnings when compiling without optimization but with most ports'
default warning flags. Clean up prototype list spacing, and make it more
consistent.
connect to their 1-wire bus like the DS2404 "EconoRAM Time Chip"
- and -
* Interface function definitions for this kind of chips. Currently only
low-level byte_read and _write, implenented as inline functions.
This functions take a struct ds_handle * (also defined here), which contains
pointers to bit-read/write and reset functions.
Eventually, prototypes for memory-access functions should go here, and the
1-wire bus should be made a BSD auto-configuration bus.
(a) The interrupt is a RESEL interrupt, and
(b) our state is SELECTING.
This condition can occur in perfectly normal operation if we are using
DMA to select the target and we are interrupted by another target
reselecting us. Per discussion with Paul Krannenburg.
Every ccb locks 64k of memory for dma buffers.
Instead of AHA_CCB_MAX ccbs using 1MByte only sc_link.openings ccbs
per device are allocated. Thus we now use only 128KByte per device present.
- If the partition is already open, skip the open/close step. (Sync
with other disk drivers.)
- foosize()'s return value is in DEV_BSIZE units; adjust the size obtained
from the disklabel accordingly.
- Pass correct arguments to ofdopen() and ofdclose().
- If the partition was previously open, don't do the open/close steps.
(Sync with other disk drivers.)
- foosize()'s return value is in DEV_BSIZE units; adjust the size obtained
from the disklabel accordingly.
greater flexibility in its use. Additionally, add support for "geometry
emulation". This allows the "geometry" of the "disk" to be specified
at config time, providing near-perfect emulation of disklabel-less floppies,
CD-ROMs, etc., including non-512-byte sectors. If a geometry is not
specified at config time, a default based on 1M cylinders will be used.
clock rate for this board on Alpha/PCI systems. Under x86/PCI, the
board f/w will correctly tell you "I'm running at 60Mhz", so the code
that preserved that across a board reset (which would drop the chip
back to 40Mhz) worked fine. On the 8200, the chip was saying "I'm 40Mhz"-
which wasn't true. This turned out to be okay as long as you didn't have
any FAST or UltraFast targets- In fact, setting the chip to 40Mhz allowed
you to run up to 8Mhz SCSI. Unfortunately you die bigtime on the devices
that go faster than that. The fix here is to only use what the chip tells
you the clock rate is in the cases you don't really know (sbus is the
only case where this could be different, although with 66Mhz PCI coming up,
this may change).
