also restructure and simplify input VLAN ID code handling somewhat, to not use
local have_vlan/vlan_tag variables, and use the appropriate cur_rx condition
on the one place where it's needed
Bump the default values for these to the values used by FreeBSD,
and also adjust ti_init_rx_ring_jumbo() to use the same constant
that FreeBSD uses. Yes, this consumes more kernel memory.
The effect of this is that you can use jumbo frames in a back-to-back
setup with TCP windows up to about 250KB and get ~930Mbit/s throughput,
while we were earlier limited to around 3-400Mbit/s, and trying to push
above that mark by widening the TCP window caused
ti0: jumbo buffer allocation failed
messages to be logged and a corresponding stall in the traffic.
As we turn the chip to big-endian mode on big-endian systems, we should
never byte-swap the data read/written from/to registers. Tested on sparc64.
Finally fix kern/13341 by Jason R. Thorpe (really, the hard work of putting
bus_dmamap_sync() calls at the right places has been done my Jason mid-2001 :)
Trimm the priority, as the upper layers won't do it and will drop the packet
if priority is not 0.
While there, print the revision in the "unsupported chip revision" printf.
- implement SIMPLEQ_REMOVE(head, elm, type, field). whilst it's O(n),
this mirrors the functionality of SLIST_REMOVE() (the other
singly-linked list type) and FreeBSD's STAILQ_REMOVE()
- remove the unnecessary elm arg from SIMPLEQ_REMOVE_HEAD().
this mirrors the functionality of SLIST_REMOVE_HEAD() (the other
singly-linked list type) and FreeBSD's STAILQ_REMOVE_HEAD()
- remove notes about SIMPLEQ not supporting arbitrary element removal
- use SIMPLEQ_FOREACH() instead of home-grown for loops
- use SIMPLEQ_EMPTY() appropriately
- use SIMPLEQ_*() instead of accessing sqh_first,sqh_last,sqe_next directly
- reorder manual page; be consistent about how the types are listed
- other minor cleanups
so that they're more useful for arbitrary types of external storage:
* Add an "mbuf *" argument to (*ext_free)(). If non-NULL, (*ext_free)()
is expected to free the mbuf itself. This allows (*ext_free)() to use
the mbuf for bookkeeping (e.g. deferring the work to a helper thread).
If the "mbuf *" argument is NULL, we are assumed to be in a context
which is safe for performing the destructor operation *now*.
* Adjust MEXTREMOVE() and MFREE() routines for above change.
* Update "ade" and "ti" drivers for new semantics.
network interfaces. This works by pre-computing the pseudo-header
checksum and caching it, delaying the actual checksum to ip_output()
if the hardware cannot perform the sum for us. In-bound checksums
can either be fully-checked by hardware, or summed up for final
verification by software. This method was modeled after how this
is done in FreeBSD, although the code is significantly different in
most places.
We don't delay checksums for IPv6/TCP, but we do take advantage of the
cached pseudo-header checksum.
Note: hardware-assisted checksumming defaults to "off". It is
enabled with ifconfig(8). See the manual page for details.
Implement hardware-assisted checksumming on the DP83820 Gigabit Ethernet,
3c90xB/3c90xC 10/100 Ethernet, and Alteon Tigon/Tigon2 Gigabit Ethernet.
if we are requested range of multicast address or too many multicast address,
program multicast filter to receive all multicast address. And set/clear
IFF_ALLMULTI flag properly.
christos