- Add support for DT transfers (aka Ultra/160) in esiop
Note that DT transfers are not enabled for 53c1010-33 rev 0 yet; if I trust
FreeBSD it has a bug which prevent them to do DT properly.
From the same source there may be issues with some revs of 53c1010-66.
taken from OpenBSD. Test hardware kindly provided by Intel. This still needs
management bits, and doesn't support older controllers, but that shouldn't
be hard to fix.
yet.
If is restricted to SIOP which implement the load/store instruction, and
has 10 scratch registers (basically, 825 and newer, possibly 770).
It implements a different interface between host and script, using a real
ring for command starts, and improved support for reconnect which will allow
256 tag per device. It uses interrupt on the fly to signal complete command,
which allows several commands to be serviced per interrupt and doesn't require
the script to stop to signal command completion.
So to disable them all better use 0xff instead of 0x00 as mask. Noted
by Matthias Drochner.
Move some initialization unrelated to interrupts back to its place at
attach time.
into a strange failure mode if we do it with disabled interrupt. When
(re-)enabling interrupts reset transmitter and receiver and clear any
pending state.
Note: The code is written a little more cruftily than it should be. It's also
only tested on the OSB4. I'm not sure it even makes sense to have support for
`native' mode, but I put it in just in case.
for the same purpose (ignoring invalid interrupts).
For cards that are not able to stop all interrupts (or we don't know a way
to do that in software, at least) run the clearirq callback even when
ignoring an interrupt because we are not enabled. Otherwise the card would
stop interrupting.
Reserve a driver specific callout handle and an int value in the generic
isic_softc to allow card drivers to implement fancy blinkenlights.
The ICH on-board Ethernet and some i82559 chips have a bug which
will cause a PCI protocol violation if the chip receives a CU_RESUME
command as it is entering the IDLE state by deasserting #CLKRUN.
(This is the so-called "resume bug" that we previously had an incomplete
work-around for on ICH chipsets.)
The work-around is to disable Dynamic Standby Mode, such that the
chip will never deasert #CLKRUN. Dynamic Standby Mode is disabled
by clearing a bit in the EEPROM and updating the EEPROM (and EEPROM
checksum).
Unfortunately, the chip will only consult the EEPROM setting after
a PCI bus reset, so a system reboot is required once the EEPROM
has been updated (the EEPROM update only needs to happen once,
and the driver usses a warning instructing the user to reboot the
system once the work-around has been applied).
Issue pointed out by David Brownlee, and code more-or-less lifted
from FreeBSD.
kleink