- Fix the SROM checksum routine.
- Add code to parse the old DEC Address ROM SROM format.
- Rearrange the statchg routines a bit, to make them consistent with one
another.
- Add support for the DECchip 21040. XXX No support for media autosense
yet, and no support for any of the multi-port boards yet.
Tree structure:
- sys/arch/sh3: sh3 generic code
As commented, in-chip device drivers are put into sys/arch/sh3/dev.
- sys/arch/evbsh3: sh3 evaluation boards (pure sh3 CPU, no fancy external HW)
- sys/arch/mmeye: Brains mmEye, www.brains.co.jp
MI source code includes couple of #ifdef for sh3-coff support.
(sh3 uses coff or elf)
Needs some more improvements, especialy in sys/arch/sh3/conf/files.sh3,
to compile the tree (due to last minute tree structure change).
protocol used by the device, e.g.:
umass0 at uhub0 port 1 configuration 1 interface 0
umass0: Iomega USB Zip 100, rev 1.00/1.00, addr 2
umass0: SCSI over Bulk-Only (iclass 8/6/80)
and issue a REQUEST SENSE. This fixes the media change problems I was
having w/ my USB ZIP drive.
- Clean up some debugging code.
- Implement more hot-unplug stuff.
ETHERTYPE_IPV6 packets are encapsulated by RFC1042 encap.
Tested with Japanese card, with WaveLan bridge (wiconfig -p 1).
NOTE: I dunno if encapsulating IPv6 packets by RFC1042 is the correct way,
as RFC1042 only defines behavior for ETHERTYPE_{IP,ARP,REVARP} packets.
Since WaveLan bridge encapsulates IPv6 packets with RFC1042, we have no
choice.
Gather joined multicast addresses via SIOCADDMULTI, and configure multicast
filter properly. This is also required for IPv6 support
(which heavily depends on multicast).
Fix IFF_RUNNING management
- to prevent IFF_RUNNING from raised on "wiconfig", before "ifconfig up"
- to prevent the driver from occupying extra interrupts on "ifconfig up",
then "down", then "up".
Drop multicast/broadcast packet looped back from myself.
This is to cope with SMC91C92 (Megahertz XJ10BT), which
loops back multicast packet to itself on promiscuous mode.
(should be ensured by chipset configuration)
Reviewed by: thorpej
- Take note of magazine changes, and enqueue "Element Status Changed" events
that user processes can read or select on.
- Normalize some structure names.
- Report back more status about changer elements:
* Volume tags (e.g. barcode labels on the backs of your tapes)
* External device names (for drive units in a changer)
* Last element a unit of media was moved from
* Sense information for SCSI changer elements in EXCEPT condition
* Vendor-specific data if the user requests it.
- Add support for setting volume tags.
the device driver instead of happening automagically in the HC driver.
This affects both the HC-USBD interface as well as the USBD-device
interface.
This change will allow DMA buffers to be reused e.g. in isochronous
traffic.
Add isochronous support to the UHCI driver (not for OHCI yet).
thorpej