- strip unnecessary loop to get command result status
- ack command after clearing busy bit
XXX: it still sometimes get timeout to get status(0xff50) or statistics(0xff68)
probably due to heavy load of firmware in receiving.
timeouts).
stop driver after suspend.
XXX: should use command interrupt but no document...
XXX: status update sometimes failed perhaps due to collision.
(RID 0xff50 or 0xff68 access failed)
Also, adjust message/command construction in ncr53c9x_select() to work no
matter how the structure alignment works out (needed at least for m68k).
Tested by me on mac68k & alpha, and sanity-checked by eeh.
Though ifconfig -m no longer show 5Mbps/11Mbps for PC4500 by this fix,
I cannot find how to set fixed transmit speed to the firmware.
FreeBSD version of driver apparently ignore the value set by ancontrol(8).
This is very adhoc work for IETF meeting.
- Since it seems that 'an' and 'wi' have similar hardware, low level
functions should be shared.
- There are PCI/ISA cards of Aironet but not supported yet.
- The wiconfig interface is changed so that wiconfig cannot be used.
- 'ancontrol' of FreeBSD is not ported.
- Only infrastructure mode is tested.
- WEP is not supported.
Though I only have an Aironet card, Cisco card should be expected to work.
The intent was to protect the full range of ports on the board by the
barriers. But the start address was wrong. Fix it.
While here, change two other barriers to also protect the full range
(not only the nic ports), and add yet another similar barrier.
quite simply a question of the Qlogic being little endian and having
to have stuff swapped on big endian machines- it also has to do with the
fact that the SBus and PCI DMA layouts are wierd with respect to this.
At any rate, now finally fixed- works on Mac G4, tested it on a SS10
for sparc, checked on alpha to see if I've broken anything, and as
soon as I get another spare afternoon I'll finally install a sparc64
version which should just work (as it'll be like the Mac).
bjh21