Soren S. Jorvang <soren@t.dk>, with a lower match level.
Display the other accented characters which are not present in the IBM
character set by their non-accented equivalents, with an even lower
match level.
* Macroize hardware and software descriptor access (much easier to read).
* Simplify and optimize the transmit loop a bit, and use IFF_OACTIVE as
appropriate.
* Fix a potential race condition in the transmit loop. This change has
made the driver significantly more stable (almost completely eliminated
the "device timeout" errors that have plagued this driver).
* Implement transmit interrupt pacing.
* Add missing bus_dmamap_sync() calls (on transmit and receive descriptors
and fraglists). (Draining the write buffer when accessing these structures
may have also contributed to the increased stability of this driver on
the Alpha.)
Use fast memory timing NVRAM parameter. Clean up and fix establishment
of default target parameters. Don't use NVRAM if are flagged as not to
do so (I had a busted NVRAM setup which I couldn't edit that enabled SYNC
mode but disabled disconnect/reconnect and wide!!). Fix delays after
resets. BUS resets not done in isp_init anymore- relegated to OS
specific outer layers. Fix a buglet where you can get in a loop for
a NULL xs in the completion list in isp_intr. Add in some defines that
can disable fast posting. Add in code for Loop Up/Loop Down events that
call into the outer layers as to what to do.
define. Add a new config flag param (ISP_CFG_NONVRAM) whose intent it is
to cause NVRAM to be ignored. Add ISPASYNC_LOOP_DOWN and ISPASYNC_LOOP_UP
isp_async enums.
(we get LOOP DOWN events, and we'll hang on that at this time).
Add other isp_async cases- ISPASYNC_LOOP_DOWN and ISPASYNC_LOOP_UP. DOWN
will cause internal queuing until UP, whereupon a timeout will fire up
any pending xfers. It doesn't really keep commands from getting destroyed
by loop down events, but at least minimizes the damage. This was much
easier to implement with CAM.
the disk is ready to transfer data, and in ATA-5 the DSC has been obsoleted.
So only wait for DRQ to transfer data. This can be made conditional on the
ATA version if it's proven to break with some drives (worked with all the
drives I have access to).
While I'm there correct a few typos.
dante