reserving RAM in the bus_mem extent map. Problem pointed
out by Artur Grabowski.
- Work around a slightly annoying bit of behavior exhibited by
the UP1000 firmware. The UP1000 firmware reports the space
consumed by the "ISA hole" in the same MDDT entry as two
chunks of RAM (on either side of the hole) used by the PALcode,
all as one "reserved for PALcode" chunk. We must take this
into account when reserving RAM in the bus_mem extent map.
pci_attach_args *" instead of from four separate parameters which in
all cases were extracted from the same "struct pci_attach_args".
This both simplifies the driver api, and allows for alternate PCI
interrupt mapping schemes, such as one using the tables described in
the Intel Multiprocessor Spec which describe interrupt wirings for
devices behind pci-pci bridges based on the device's location rather
the bridge's location.
Tested on alpha and i386; welcome to 1.5Q
(Lynx), written from scratch by me over a year ago, but never committed
to the tree because there was a bug I could never quite find. I have
fixed a few problems in the code, but still don't know if that bug is
quite fixed. Since I don't have access to the hardware directly, I'll
have to call for testers again.
work-around. It's required in order for the DEC Multia (a very
brain-damaged little machine) to work properly.
Submitted by Juergen Weiss <weiss@uni-mainz.de>, addresses
port-alpha/11202.
have an ISA chipset present before the PCI-EISA bridge has been
attached (because the STDIO module has an ISA DMA-using device,
the floppy controller, connected to it).
the `get window' method ends up with the wrong physical address to
pass onto userspace (which wants to mmap the space).
Compensate by adding a CHIP_PHYSADDR() macro which un-hacks the address
suitably for mapping with other-than-KSEG.
- Add sysarch methods for "get bus window count", "get bus window",
and "pci conf read/write".
These are a hack, but they're what's necessary in order to make
XFree86 work in its current state.
of adjacent DMA segments.
XXX This is still not perfect... but making it perfect will probably
require additions to the bus_dma interface and the ISA autoconfiguration
interface.
thorpej