* New patchable variable maxphysmem to limit physical memory.
That's useful to simulate small machines for testing install
kernels.
* Make debugging crashdumps with gdb -k work.
* microtime is moved to clock.c.
* Reserve memory for symbol table when ddb is configured.
* Move checks for RB_KDB into consinit.
* Fix a typo in delay().
* Disable generation of profiling prologue for proc_trampoline,
sigcode, idle, handle_trap, flush_icache, svc and interrupt.
* A few tweaks to make kgdb and ddb work nicer.
* Support for bpf added.
* Don't duplicate code, use ether_ifattach instead.
* Recode plipreceive and pliptransmit in assembler.
This improves performance from 40 kbyte/s to 50 kbyte/s
between a 30mhz pc532 and a 25mhz i386.
make that fail on some machines. Rather, since the code wants to access
the data both ways, use a structure and treat that structure as an array
of chars where appropriate.
dev/microcode/aic7xxx_seq.h,
dev/ic/aic7xxxreg.h:
Remove intrinsic knowledge about SDTR and WDTR messages and replace it
with a generic message system that allows the kernel driver to handle
SDTR, WDTR and any other type of extended message it chooses too. This
makes the sequencer code much simpler, makes extended message handling
debuggable since the bulk of the work is in the kernel driver, and saves
lots of instruction space.
Regen microcode header file.
dev/ic/aic7xxx.c, dev/ic/aic7xxxvar.h:
Add code to handle WDTR and SDTR negotiation in light of the changes in
the message interface to the sequencer. Don't reject targets that
negotiate async by sending an SDTR with a 0 offset. Use an sdtr message
with 0,0 to negotiate async when a target suggests a period that is too
long for us to handle. Some tape and cdrom drives don't like us doing
the message reject that we did in the past.
Fix a problem with handing the QUEUE FULL condition.
Fix a race condition (most likely the cause of the SCB paging problems) that
might allow the sequencer to get unpaused before the condition that caused
it to be paused (a SEQINT) was handled.
Race condition pointed out by Doug Ledford <dledford@dialnet.net> and
by "Dan Willis" <dan@plutotech.com>.
dev/pci/ahc_pci.c:
Add support for the 2940AU, an aic7860 based controller.
dev/pci/pcidevs.h, dev/pci/pcidevs_data.h:
Add product IDs for the 2940AU, aic7860 and aic7855.
Regen data file.
scsi/scsi_message.h:
Add MSG_EXT_SDTR_LEN and MSG_EXT_WDTR_LEN - the length of bytes in these
extended messages.
Thanks to Chuck Cranor <chuck@maria.wustl.edu> for testing these changes
out for me.
