- allow vnddetach() to return EBUSY if any vnd's are currently initialised.
lkm:
- add new 'dev' directory, initially with just a 'vnd' LKM. for now, the
vnd lkm driver requests 4 devices....
XXX: vnd should be converted to a psuedo-device that creates & deletes
instances of itself (vnd0, vnd1, etc) when vnconfig -c/-u are called,
then the vnd lkm driver can not be limited to '4' by default.
WI_RID_DBM_ADJUST: In preparation for capturing Prism packets
containing received signal strength indications (RSSI), read the
constant for conversion from RSSI to dBm (decibels relative to
a milliwatt).
WI_RID_FRAG_THRESH: Get/set the packet fragmentation threshold
on Lucent/Prism.
> Remove an entry for AMD PCNETS_PCI.
>
> AMD Am79C974 PCnet-SCSI Ethernet and SCSI conrtoller is
> a multi-function PCI device which has two device IDs
> of Am53C974(PCscsi-PCI) and Am79C970(PCnet-PCI),
> and there is no its own ID.
AMD Am79C974 PCnet-SCSI Ethernet and SCSI conrtoller is
a multi-function PCI device which has two device IDs
of Am53C974(PCscsi-PCI) and Am79C970(PCnet-PCI),
and there is no its own ID.
original system call number, which can be negative for a Mach trap.
We cannot just replace code by realcode, because ktrsyscall uses it as
an index in the system call table, thus crashing the kernel when the
value is negative.
delay freeing the old am_ppref so that if we bail early due to
malloc() failures, valid ppref data hasn't been freed for no reason.
Based on comments from enami.
- Move lm_readreg/lm_writereg into the front-ends. Add/use function pointers
in the softc.
- Add a bank select function pointer to the softc and provide a generic
version. WinBond chips accessed over serial bus present three addresses,
two of which are used to access bank 1/2 registers.
- Mark TSENS2/3 sensor data as invalid if the the corresponding bank select
fails.
The posix 'sh' specification defines vi-mode editing quite tightly.
The netbsd libedit code (used by sh to do this) was missing several
features, there were also minor errors in others.
Compare netbsd sh to the definition available from:
http://www.opengroup.org/onlinepubs/007904975/utilities/sh.html
In particular the following were not supported:
U - undo all changes to line
| - goto column
Y - yank to end of line
y - yank
# - comment out current line
@ - take input from shell alias [1]
G - goto numbered line in history buffer
v - edit history line with vi
_ - append word from last input line
. - redo last command
Other minor changes have also been made.
[1] This needs the shell to define an appropriate routine to
return the text of the alias. There is no requirement that
such a function exist.
itojun