If we get a completion status of RQCS_QUEUE_FULL, it means
that the internal queues are full. Other QLogic boards set
the QFULL SCSI status. But *nooooooooooo*, not the 2300.
gem_mediachange(). This will cause gem_mii_statchg() to be called
by the MII layer with the correct MII media state, so that speed
duplex parameters will be set properly.
8 port chip. this is used in several sbus (sparc) serial boards, as
well as an 8 port isa card from riscom. sio16 (sbus) frontend coming
shortly.
this is heavily based on the com and zs drivers.
(1) Add an IOCTL to tell the Lucent based cards how often to
do an access point scan. These results are returned by
calling another IOCTL to get the most recent scan data.
This function works with prism2 cards as well, but the
data is returned in a different format, or perhaps it is
data only for the closest access point.
(2) For prism2 cards, add the ability to put it into LAN monitor
mode, where (via BPF) all packets can be received. This
mode works best with "wiconfig wi0 -p 3 -f ?" to put the
card into pseudo-IBSS mode (to keep it from channel-hopping
and scanning for access points) and to set the frequency of
the AP you wish to monitor.
The returned data has a partial wi_frame header (down to the
wi_dat_len field) followed by the raw data of the packet.
I have and will put up on http://www.flame.org/NetBSD/wireless/
some simple utilities which do some perhaps interesting things,
like scan for access points, capture packets, etc.
XXX: FH chanset should be calculated by FH hop pattern, but BayStack 650 AP
always specify chanset to fixed value 1. The previous code try to this
hack into awi driver, but it is insufficient because the chanset value
in awi driver may change while scan and it may be different from the
value in receiving beacon/probe-response. So we save encoded FH chanset
into channel in 802.11 common bss information for now.
if_ieee80211subr.c, which can be shared between any IEEE 802.11
drivers.
However, most of current working IEEE 802.11b wireless LAN cards
have rich firmware and we cannot have a control to management frames
for such cards.
IBSS creation is now supported for the awi driver.
IIR_NOPEND if the TXRDY condition is true. Apparently, other chips do
not take TXRDY into account in the IIR_NOPEND case.
Also remove useless assignment (iir = IIR_NOPEND;) in one case.
No response from patch posted on tech-kern 29Aug2001.
Temp work around problems where if we allow for non-polled mailbox commands
we got nailed by hardclock calling is for a timed thaw. Basically, this
means we only enable non-polled mailbox commands in the FC kthread when it
calls isp_fc_runstate.
