- initialize it properly in the bus front-ends (all 2, exept in wdc_pcmcia.c
for the "Sandisk CompactFlash Card" where it's set to 1)
- remplace hardcoded '2' by ata_channel->ch_ndrive in MI IDE drivers.
From Christos Zoulas in kern/32501.
- kernel (both dom0 and domU) boot, console is functionnal and it can starts
software from a ramdisk
- there is no driver front-end expect console for domU yet.
- dom0 can probe devices and ex(4) work when Xen3 is booted without acpi
and apic support. But the on-board IDE doens't get interrupts.
The PCI code still needs work (it's hardcoded to mode 1). Some of this
code should be shared with ../x86
The physical insterrupt code needs to get MPBIOS and ACPI support, and
do interrupt routing to properly interract with Xen.
To enable Xen-3.0 support, add
options XEN3
to your kernel config file (this will disable Xen2 support)
Changes affecting Xen-2.0 support (no functionnal changes intended):
- get more constants from genassym for assembly code
- remove some unneeded registers move from start()
- map the shared info page from start(), and remove the pte = 0xffffffff hack
- vector.S: in hypervisor_callback() make sure %esi points to
HYPERVISOR_shared_info before accessing the info page. Remplace some
hand-written assembly with the equivalent macro defined in frameasm.h
- more debug code, dissabled by default.
while here added my copyright on some files I worked on in 2005.
asks you where to load stuff from.
Initialise stuff so that 'install default set of sets' works.
Fix install loop, removing infinite loop if/when first kernel not selected.
a u_int64_t variable). Fixes 1 to 2 TB disks in qemu. Tested with
1200GB and to a lesser extent 2047GB sparse files. For reference
an empty FFS1 filesystem on a 1200GB sparse file uses 19GB of disk.
0: No output. Default for mount_mfs unless -N specified
1: Output size of partition and cylinder groups.
2: Follow with a progress-bar line of dots (scaled to finish at RH margin)
3: Include a single line of alternate suberblock addresses before progress
bar. Default for newfs.
4: Output lots of lines of alternate superblock numbers that scroll madly
up the screen.
If -N given, newfs/mount_mfs exits before displaying any progress bar.
Output constrained (almost always) to 1 column less than the terminal width.
size. This makes ksyms work, constructed ELF header was too big to
fit into one tagged page.
As a side effect it makes detached miniroot work too, as to locate the
miniroot the symbol table must be correctly skipped. We probably
should just pass that information in bootinfo.
