board. The DE425 is basically a DECchip 21040 on an EISA board, plus
a Cool Address Decoder Hack which maps the PCI configuration
space registers into EISA I/O space, interleaved with the Tulip CSRs,
which are spaced further apart than on the PCI versoin.
This is currently *untested* until the DE425 boards that folks have
promised me arrive. But, it should work, since the 21040 works.
in a single directory. This is useful in "make build" because by doing
the build immediately after the depend, all sources will typically
still be in the buffer cache, thus saving significant time over doing
a "make depend" on all the directories and then a "make all".
- Fix the SROM checksum routine.
- Add code to parse the old DEC Address ROM SROM format.
- Rearrange the statchg routines a bit, to make them consistent with one
another.
- Add support for the DECchip 21040. XXX No support for media autosense
yet, and no support for any of the multi-port boards yet.
This situation happens on severe memory shortage. We may need more
improvements here and there.
- Grab IEEE802 address from IFT_ETHER card, even if the card is
inserted after bootup time. Is there any other card that can be
inserted afterwards? pcmcia fddi card? :-P
- RFC2373 u bit handling suggests that we SHOULD NOT copy interface id from
ethernet card to pseudo interface, when ethernet card has IEEE802/EUI64
with u bit != 0 (this means that IEEE802/EUI64 is not universally unique).
Do not use such address as, for example, interface id for gif interface.
(I have such an ethernet card myself)
This may change interface id for your gif interface. be careful upgrading
rc files.
(sync with recent KAME)
Tree structure:
- sys/arch/sh3: sh3 generic code
As commented, in-chip device drivers are put into sys/arch/sh3/dev.
- sys/arch/evbsh3: sh3 evaluation boards (pure sh3 CPU, no fancy external HW)
- sys/arch/mmeye: Brains mmEye, www.brains.co.jp
MI source code includes couple of #ifdef for sh3-coff support.
(sh3 uses coff or elf)
Needs some more improvements, especialy in sys/arch/sh3/conf/files.sh3,
to compile the tree (due to last minute tree structure change).