- make sure all sigreturn error conditions are reported to the caller,
instead of the place jumped to.
This is the bugfix part of pr 4628 by ITOH Yasufumi.
The performance optimization part will be handled seperately, after evaluating
its implications.
Testing on 68040 and removing the performance change from the proposed patch
by scottr. Half of the Amiga machdep.c change had to be done manually by me,
as the patchfile didn't apply cleanly.
XXX Yes, Amiga should be changed to use the common sig_machdep.c instead.
XXX Really soon now. I promise.
was converted to use Mach VM for Net2/4.4BSD. The user segment table
pointer was originally stored in the PCB. When Mach VM came along,
however, it was also stored in the pmap, and loaded into the PCB in
pmap_activate(). pmap_activate() would then note that the PCB's USTP
was now in sync with the pmap's USTP, and the low-level context switch
code would use the value from the PCB.
However, pmap_activate() would also load the hardware MMU context if
the pmap was the current pmap (or, in the case where pmaps can be shared,
such as in NetBSD, if the proc was the current proc). The low-level
context switch code would then reload the hardware _again_ using the
USTP from the PCB.
However, the optimization of not calling pmap_activate() if "stchanged"
was false ended up causing some processes to use stale USTP values from
the PCB when the low-level context switch code reloaded the hardware!
This was noticed by using a real vfork(2) (which worked for some time
before failing, surprisingly!)
Since I'm hard pressed to find any real optimization here (since the
hardware was always reloaded once, sometimes twice!), the code now always
calls pmap_activate(), which uses the correct USTP value (the one in the
pmap). The PCB's USTP is now ignored, and should eventually be g/c'd.
Another optimization can actually be performed, and I have added a comment
describing what it is, but have not yet implemented it.
Also note that most of the loadustp() functions where actually incomplete.
This has been corrected. These functions should probably be split up into
MMU-specific operations, and called indirectly, rather than doing constant
run-time decision making based on values that will never change during the
course of a boot's lifetime.
We play mono samples on all 4 channels.
However, we get the volume settings for mono samples as a symmetic two-channel
setting... the other two channels used to stay at max volume...
I believe that something else is wrong here, but dont want to change MI
code (which in turn influences a couple of MD driver) thus late in the release
cycle.
- use board address space > 4 MB, instead of iszthreepa(), to detect Z3-mode
boards. We dont want the bus, but want the address configuration.
- s/CV64CONSOLE/CV3DCONSOLE/
- s/cv3d_zorroIII == 1/cv3d_zorroIII/ and s/cv3d_zorroIII != 1/!cv3d_zorroIII/
the CyberVision64 driver. Modified by Tobias Abt with some bugfixes
from Bernd Ernesti.
ZorroII is at the moment not supported and there is a small problem
with the Console driver where you just get a black screen, but the
system boots and you can use X11 without a problem.
The changes is to allow some limited mixer manipulation through
the audio device (instead of the mixer device).
This rendered 4 methods in audio_hw_if unused so garbage collect these.
