6b827cca9a
Change Makefile.objs to use CONFIG_XEN instead of CONFIG_XEN_BACKEND, so that the Xen backends are only built for targets that support Xen. Set CONFIG_XEN in the toplevel Makefile to ensure that files that are built only once pick up Xen support properly. Signed-off-by: Stefano Stabellini <stefano@aporeto.com> Tested-by: Greg Kurz <groug@kaod.org> Reviewed-by: Greg Kurz <groug@kaod.org> CC: pbonzini@redhat.com CC: peter.maydell@linaro.org CC: rth@twiddle.net CC: stefanha@redhat.com Message-Id: <1489694518-16978-1-git-send-email-sstabellini@kernel.org> Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
32 lines
1.2 KiB
Makefile
32 lines
1.2 KiB
Makefile
common-obj-$(CONFIG_IPACK) += ipoctal232.o
|
|
common-obj-$(CONFIG_ESCC) += escc.o
|
|
common-obj-$(CONFIG_PARALLEL) += parallel.o
|
|
common-obj-$(CONFIG_PL011) += pl011.o
|
|
common-obj-$(CONFIG_SERIAL) += serial.o
|
|
common-obj-$(CONFIG_SERIAL_ISA) += serial-isa.o
|
|
common-obj-$(CONFIG_SERIAL_PCI) += serial-pci.o
|
|
common-obj-$(CONFIG_VIRTIO) += virtio-console.o
|
|
common-obj-$(CONFIG_XILINX) += xilinx_uartlite.o
|
|
common-obj-$(CONFIG_XEN) += xen_console.o
|
|
common-obj-$(CONFIG_CADENCE) += cadence_uart.o
|
|
|
|
obj-$(CONFIG_EXYNOS4) += exynos4210_uart.o
|
|
obj-$(CONFIG_COLDFIRE) += mcf_uart.o
|
|
obj-$(CONFIG_OMAP) += omap_uart.o
|
|
obj-$(CONFIG_SH4) += sh_serial.o
|
|
obj-$(CONFIG_PSERIES) += spapr_vty.o
|
|
obj-$(CONFIG_DIGIC) += digic-uart.o
|
|
obj-$(CONFIG_STM32F2XX_USART) += stm32f2xx_usart.o
|
|
obj-$(CONFIG_RASPI) += bcm2835_aux.o
|
|
|
|
common-obj-$(CONFIG_ETRAXFS) += etraxfs_ser.o
|
|
common-obj-$(CONFIG_ISA_DEBUG) += debugcon.o
|
|
common-obj-$(CONFIG_GRLIB) += grlib_apbuart.o
|
|
common-obj-$(CONFIG_IMX) += imx_serial.o
|
|
common-obj-$(CONFIG_LM32) += lm32_juart.o
|
|
common-obj-$(CONFIG_LM32) += lm32_uart.o
|
|
common-obj-$(CONFIG_MILKYMIST) += milkymist-uart.o
|
|
common-obj-$(CONFIG_SCLPCONSOLE) += sclpconsole.o sclpconsole-lm.o
|
|
|
|
obj-$(CONFIG_VIRTIO) += virtio-serial-bus.o
|