Commit b9d03e352c added link
auto-negotiation emulation, it would always set link up by
callback function. Problem exists if original link status
was down, link status should not be changed in auto-negotiation.
Signed-off-by: Jason Wang <jasowang@redhat.com>
Signed-off-by: Amos Kong <akong@redhat.com>
Signed-off-by: Stefan Hajnoczi <stefanha@redhat.com>
We don't clean up network if fails to parse "-device" parameters without
calling net_cleanup(). I touch a problem, the tap device which is
created by qemu-ifup script could not be removed by qemu-ifdown script.
Some similar problems also exist in vl.c
In this patch, if network initialization successes, a cleanup function
will be registered to be called at qemu process termination.
Signed-off-by: Amos Kong <akong@redhat.com>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Stefan Hajnoczi <stefanha@redhat.com>
Discard packets longer than 16384 when !SBP to match the hardware behavior.
Signed-off-by: Michael Contreras <michael@inetric.com>
Signed-off-by: Stefan Hajnoczi <stefanha@redhat.com>
Add support for compiling for GCOV test coverage, enabled
with '--enable-gcov' during configure.
Test coverage will be reported after each test.
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
The division routines do not read or write tcg registers,
but can raise fixed-point divide exceptions.
Signed-off-by: Richard Henderson <rth@twiddle.net>
Don't load the displacement into a register first, add it second
so that tcg_gen_addi_i64 can eliminate zeros. Don't mask the
displacement first so that we don't turn small negative numbers
into large positive numbers.
Signed-off-by: Richard Henderson <rth@twiddle.net>
Giving the proper mask to disas_jcc allows us to generate an inline
comparison generating the carry/borrow with setcond.
In the very worst case, when we must use the external helper to compute
a value for CC, we generate (cc > 1) instead of (cc >> 1), which is only
very slightly slower on common cpus.
In the very best case, when the CC comes from a COMPARE insn and the
compiler is using ALCG with zero, everything folds out to become just
the setcond that the compiler wanted.
Signed-off-by: Richard Henderson <rth@twiddle.net>
After full conversion, we can audit the uses of LTGT cc ops
and see that none of the instructions can ever set CC=3.
Thus we can extend the table to treat that bit as ignored.
This fixes a regression wrt the pre-conversion translation
in which NE was used for both m=6 and m=7.
Signed-off-by: Richard Henderson <rth@twiddle.net>
While they aren't expensive, they aren't free to process. When we
know that the three cc helper variables are dead, don't kill them.
Signed-off-by: Richard Henderson <rth@twiddle.net>
There's no need to force computation of the true cc_op when taking an
exception or single stepping. In either case we'll enter the next TB
with s->cc_op = DYNAMIC and recompute anyway. Just make sure that
s->cc_op is stored back to env->cc_op as needed.
Delete some dead functions, avoid allocating unused TCG temps, drop
the old s->is_jmp setting.
Signed-off-by: Richard Henderson <rth@twiddle.net>
The use of inline restricts detection of static functions that are
no longer used. Limit the use of inline to those functions that
are conditionally used based on CONFIG_USER_ONLY.
Signed-off-by: Richard Henderson <rth@twiddle.net>
While we're at it, list all of the chapter 14 subchannel insns.
Which is easy since all merely need indicate non-operation.
Signed-off-by: Richard Henderson <rth@twiddle.net>
