The io_readx() function needs to know whether the load it is
doing is an MMU_DATA_LOAD or an MMU_INST_FETCH, so that it
can pass the right value to the cpu_transaction_failed()
function. Plumb this information through from the softmmu
code.
This is currently not often going to give the wrong answer,
because usually instruction fetches go via get_page_addr_code().
However once we switch over to handling execution from non-RAM by
creating single-insn TBs, the path for an insn fetch to generate
a bus error will be through cpu_ld*_code() and io_readx(),
so without this change we will generate a d-side fault when we
should generate an i-side fault.
We also have to pass the access type via a CPU struct global
down to unassigned_mem_read(), for the benefit of the targets
which still use the cpu_unassigned_access() hook (m68k, mips,
sparc, xtensa).
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Tested-by: Cédric Le Goater <clg@kaod.org>
Message-id: 20180710160013.26559-2-peter.maydell@linaro.org
The condition to check whether an address has hit against a particular
TLB entry is not completely trivial. We do this in various places, and
in fact in one place (get_page_addr_code()) we have got the condition
wrong. Abstract it out into new tlb_hit() and tlb_hit_page() inline
functions (one for a known-page-aligned address and one for an
arbitrary address), and use them in all the places where we had the
condition correct.
This is a no-behaviour-change patch; we leave fixing the buggy
code in get_page_addr_code() to a subsequent patch.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Message-Id: <20180629162122.19376-2-peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Add support for MMU protection regions that are smaller than
TARGET_PAGE_SIZE. We do this by marking the TLB entry for those
pages with a flag TLB_RECHECK. This flag causes us to always
take the slow-path for accesses. In the slow path we can then
special case them to always call tlb_fill() again, so we have
the correct information for the exact address being accessed.
This change allows us to handle reading and writing from small
regions; we cannot deal with execution from the small region.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20180620130619.11362-2-peter.maydell@linaro.org
The MC68040 MMU provides the size of the access that
triggers the page fault.
This size is set in the Special Status Word which
is written in the stack frame of the access fault
exception.
So we need the size in m68k_cpu_unassigned_access() and
m68k_cpu_handle_mmu_fault().
To be able to do that, this patch modifies the prototype of
handle_mmu_fault handler, tlb_fill() and probe_write().
do_unassigned_access() already includes a size parameter.
This patch also updates handle_mmu_fault handlers and
tlb_fill() of all targets (only parameter, no code change).
Signed-off-by: Laurent Vivier <laurent@vivier.eu>
Reviewed-by: David Hildenbrand <david@redhat.com>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20180118193846.24953-2-laurent@vivier.eu>
Background: s390x implements Low-Address Protection (LAP). If LAP is
enabled, writing to effective addresses (before any translation)
0-511 and 4096-4607 triggers a protection exception.
So we have subpage protection on the first two pages of every address
space (where the lowcore - the CPU private data resides).
By immediately invalidating the write entry but allowing the caller to
continue, we force every write access onto these first two pages into
the slow path. we will get a tlb fault with the specific accessed
addresses and can then evaluate if protection applies or not.
We have to make sure to ignore the invalid bit if tlb_fill() succeeds.
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20171016202358.3633-2-david@redhat.com>
Signed-off-by: Cornelia Huck <cohuck@redhat.com>
The header is only used by accel/tcg/cputlb.c so we can
move it to the accel/tcg/ folder, too.
Signed-off-by: Thomas Huth <thuth@redhat.com>
[PMD: reword commit title to match series]
Signed-off-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Message-Id: <20170911213328.9701-2-f4bug@amsat.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
