... by default. Add a per-device "permissive" mode similar to pciback's
to allow restoring previous behavior (and hence break security again,
i.e. should be used only for trusted guests).
This is part of XSA-131.
Signed-off-by: Jan Beulich <jbeulich@suse.com>
Acked-by: Stefano Stabellini <stefano.stabellini@eu.citrix.com>
Reviewed-by: Anthony PERARD <anthony.perard@citrix.com>)
The adjustments are solely to make the subsequent patches work right
(and hence make the patch set consistent), namely if permissive mode
(introduced by the last patch) gets used (as both reserved registers
and reserved fields must be similarly protected from guest access in
default mode, but the guest should be allowed access to them in
permissive mode).
This is a preparatory patch for XSA-131.
Signed-off-by: Jan Beulich <jbeulich@suse.com>
Limit error messages resulting from bad guest behavior to avoid allowing
the guest to cause the control domain's disk to fill.
The first message in pci_msix_write() can simply be deleted, as this
is indeed bad guest behavior, but such out of bounds writes don't
really need to be logged.
The second one is more problematic, as there guest behavior may only
appear to be wrong: For one, the old logic didn't take the mask-all bit
into account. And then this shouldn't depend on host device state (i.e.
the host may have masked the entry without the guest having done so).
Plus these writes shouldn't be dropped even when an entry is unmasked.
Instead, if they can't be made take effect right away, they should take
effect on the next unmasking or enabling operation - the specification
explicitly describes such caching behavior. Until we can validly drop
the message (implementing such caching/latching behavior), issue the
message just once per MSI-X table entry.
Note that the log message in pci_msix_read() similar to the one being
removed here is not an issue: "addr" being of unsigned type, and the
maximum size of the MSI-X table being 32k, entry_nr simply can't be
negative and hence the conditonal guarding issuing of the message will
never be true.
This is XSA-130.
Signed-off-by: Jan Beulich <jbeulich@suse.com>
Reviewed-by: Stefano Stabellini <stefano.stabellini@eu.citrix.com>
The old logic didn't work as intended when an access spanned multiple
fields (for example a 32-bit access to the location of the MSI Message
Data field with the high 16 bits not being covered by any known field).
Remove it and derive which fields not to write to from the accessed
fields' emulation masks: When they're all ones, there's no point in
doing any host write.
This fixes a secondary issue at once: We obviously shouldn't make any
host write attempt when already the host read failed.
This is XSA-128.
Signed-off-by: Jan Beulich <jbeulich@suse.com>
Reviewed-by: Stefano Stabellini <stefano.stabellini@eu.citrix.com>
