Coverity currently complains that the "if (0x00 & (0x80 >> (phase - 8))"
in next-cube.c can never be true. Right it is. The "0x00" is meant as value
of the control register of the RTC, which is currently not implemented yet.
Thus, let's add a register variable for this now. However, the RTC
registers are currently defined as static variables in nextscr2_write(),
which is quite ugly. Thus let's also move the RTC variables to the main
machine state instead. In the long run, we should likely even refactor
the whole RTC code into a separate device in a separate file, but that's
something for calm winter nights later... as a first step, cleaning up
the static variables and shutting up the warning from Coverity should
be sufficient.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20190921091738.26953-1-huth@tuxfamily.org>
Signed-off-by: Thomas Huth <huth@tuxfamily.org>
The NeXTcube uses a normal 8530 serial controller, so we can simply use
our normal "escc" device here.
While we're at it, also add a boot-serial-test for the next-cube machine,
now that the serial output works.
Tested-by: Philippe Mathieu-Daudé <philmd@redhat.com>
Message-Id: <20190831074519.32613-6-huth@tuxfamily.org>
Signed-off-by: Thomas Huth <huth@tuxfamily.org>
It is still quite incomplete (no SCSI, no floppy emulation, no network,
etc.), but the firmware already shows up the debug monitor prompt in the
framebuffer display, so at least the very basics are already working.
This code has been taken from Bryce Lanham's GSoC 2011 NeXT branch at
https://github.com/blanham/qemu-NeXT/blob/next-cube/hw/next-cube.c
and altered quite a bit to fit the latest interface and coding conventions
of the current QEMU.
Tested-by: Philippe Mathieu-Daudé <philmd@redhat.com>
Message-Id: <20190831074519.32613-4-huth@tuxfamily.org>
Signed-off-by: Thomas Huth <huth@tuxfamily.org>
