Callers must pass ELF machine, byte swapping and symbol LSB clearing
information to ELF loader. A.out loader needs page size information, pass
that too as a parameter.
Extract prototypes to a separate file. Move loader.[ch] and elf_ops.h under hw.
Adjust callers. Also use target_phys_addr_t instead of target_ulong for
addresses: loader addresses aren't virtual.
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
virtio-pci depends, and will always depend, on pci.c
so it makes sense to keep it in the same makefile,
(unlike the rest of virtio files which should eventually
be moved out to Makefile.hw).
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
Now we have to variables: QEMU_CFLAGS: flags without which we can't compile
CFLAGS: "-g -O2"
We can now run:
make CFLAGS="-fbar" foo.o
make CFLAGS="" foo.o
make CFLAGS="-O3" foo.o
And it all should work.
Signed-off-by: Juan Quintela <quintela@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
Message-Id:
This patch is a major overhaul of the device properties. The properties
are saved directly in the device state struct now, the linked list of
property values is gone.
Advantages:
* We don't have to maintain the list with the property values.
* The value in the property list and the value actually used by
the device can't go out of sync any more (used to happen for
the pci.devfn == -1 case) because there is only one place where
the value is stored.
* A record describing the property is required now, you can't set
random properties any more.
There are bus-specific and device-specific properties. The former
should be used for properties common to all bus drivers. Typical
use case is bus addressing, i.e. pci.devfn and i2c.address.
Properties have a PropertyInfo struct attached with name, size and
function pointers to parse and print properties. A few common property
types have PropertyInfos defined in qdev-properties.c. Drivers are free
to implement their own very special property parsers if needed.
Properties can have default values. If unset they are zero-filled.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
Add a dummy command to the all: rule in sub-makefiles.
This avoids "Nothing to be done for `all'." messages from make.
Signed-off-by: Paul Brook <paul@codesourcery.com>
From Paul Brook:
"the fdc is tied to the ISA DMA engine. We don't currently have a target
independent method of handling inter-device data transfer."
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
The only target dependency for most hardware is sizeof(target_phys_addr_t).
Build these files into a convenience library, and use that instead of
building for every target.
Remove and poison various target specific macros to avoid bogus target
dependencies creeping back in.
Big/Little endian is not handled because devices should not know or care
about this to start with.
Signed-off-by: Paul Brook <paul@codesourcery.com>
