This is an oversight from bbe0a81d, where the equivalent option exists
in pg_dump. This is useful to be able to reset the compression methods
cluster-wide when restoring the data based on default_toast_compression.
Reviewed-by: Daniel Gustafsson, Tom Lane
Discussion: https://postgr.es/m/YKHC+qCJvzCRVCpY@paquier.xyz
Allowing only on/off meant that all either all existing configuration
guides would become obsolete if we disabled it by default, or that we
would have to accept a performance loss in the default config if we
enabled it by default. By allowing 'auto' as a middle ground, the
performance cost is only paid by those who enable pg_stat_statements and
similar modules.
I only edited the release notes to comment-out a paragraph that is now
factually wrong; further edits are probably needed to describe the
related change in more detail.
Author: Julien Rouhaud <rjuju123@gmail.com>
Reviewed-by: Justin Pryzby <pryzby@telsasoft.com>
Discussion: https://postgr.es/m/20210513002623.eugftm4nk2lvvks3@nol
Formerly we just relied on operator classes that assert longValuesOK
to eventually shorten the leaf value enough to fit on an index page.
That fails since the introduction of INCLUDE-column support (commit
09c1c6ab4), because the INCLUDE columns might alone take up more
than a page, meaning no amount of leaf-datum compaction will get
the job done. At least with spgtextproc.c, that leads to an infinite
loop, since spgtextproc.c won't throw an error for not being able
to shorten the leaf datum anymore.
To fix without breaking cases that would otherwise work, add logic
to spgdoinsert() to verify that the leaf tuple size is decreasing
after each "choose" step. Some opclasses might not decrease the
size on every single cycle, and in any case, alignment roundoff
of the tuple size could obscure small gains. Therefore, allow
up to 10 cycles without additional savings before throwing an
error. (Perhaps this number will need adjustment, but it seems
quite generous right now.)
As long as we've developed this logic, let's back-patch it.
The back branches don't have INCLUDE columns to worry about, but
this seems like a good defense against possible bugs in operator
classes. We already know that an infinite loop here is pretty
unpleasant, so having a defense seems to outweigh the risk of
breaking things. (Note that spgtextproc.c is actually the only
known opclass with longValuesOK support, so that this is all moot
for known non-core opclasses anyway.)
Per report from Dilip Kumar.
Discussion: https://postgr.es/m/CAFiTN-uxP_soPhVG840tRMQTBmtA_f_Y8N51G7DKYYqDh7XN-A@mail.gmail.com
This explains the new behavior introduced by 0827e8af70f4 as well as
preexisting.
Author: Justin Pryzby <pryzby@telsasoft.com>
Author: Álvaro Herrera <alvherre@alvh.no-ip.org>
Discussion: https://postgr.es/m/20210423180152.GA17270@telsasoft.com
Make sample like_regex match string values of the root object instead of the
whole document. The corrected example seems to represent a more relevant
use case.
Backpatch to 12, when jsonpath was introduced.
Discussion: https://postgr.es/m/13440f8b-4c1f-5875-c8e3-f3f65606af2f%40xs4all.nl
Author: Erik Rijkers
Reviewed-by: Michael Paquier, Alexander Korotkov
Backpatch-through: 12
EXPLAIN ANALYZE for an async-capable ForeignScan node associated with
postgres_fdw is done just by using instrumentation for ExecProcNode()
called from the node's callbacks, causing the following problems:
1) If the remote table to scan is empty, the node is incorrectly
considered as "never executed" by the command even if the node is
executed, as ExecProcNode() isn't called from the node's callbacks at
all in that case.
2) The command fails to collect timings for things other than
ExecProcNode() done in the node, such as creating a cursor for the
node's remote query.
To fix these problems, add instrumentation for async-capable nodes, and
modify postgres_fdw accordingly.
My oversight in commit 27e1f1456.
While at it, update a comment for the AsyncRequest struct in execnodes.h
and the documentation for the ForeignAsyncRequest API in fdwhandler.sgml
to match the code in ExecAsyncAppendResponse() in nodeAppend.c, and fix
typos in comments in nodeAppend.c.
Per report from Andrey Lepikhov, though I didn't use his patch.
Reviewed-by: Andrey Lepikhov
Discussion: https://postgr.es/m/2eb662bb-105d-fc20-7412-2f027cc3ca72%40postgrespro.ru
Since its introduction in bbe0a81, compression of table data supports
LZ4, but nothing had been done within the MSVC scripts to allow users to
build the code with this library.
This commit closes the gap by extending the MSVC scripts to be able to
build optionally with LZ4. Getting libraries that can be used for
compilation and execution is possible as LZ4 can be compiled down to
MSVC 2010 using its source tarball. MinGW may require extra efforts to
be able to work, and I have been able to test this only with MSVC, still
this is better than nothing to give users a way to test the feature on
Windows.
Author: Dilip Kumar
Reviewed-by: Michael Paquier
Discussion: https://postgr.es/m/YJPdNeF68XpwDDki@paquier.xyz
"make dist", in charge of creating a distribution tarball, failed when
attempting to generate ./INSTALL as a new reference added to
guc-default-toast-compression on the documentation for the installation
details was not getting translated properly to plain text. Like all the
other link references on this page, this adds a new entry to
standalone-profile.xsl to allow the generation of ./INSTALL to finish
properly.
Oversight in 02a93e7, per buildfarm member guaibasaurus.
This set of commits has some bugs with known fixes, but at this late
stage in the release cycle it seems best to revert and resubmit next
time, along with some new automated test coverage for this whole area.
Commits reverted:
dc88460c: Doc: Review for "Optionally prefetch referenced data in recovery."
1d257577: Optionally prefetch referenced data in recovery.
f003d9f8: Add circular WAL decoding buffer.
323cbe7c: Remove read_page callback from XLogReader.
Remove the new GUC group WAL_RECOVERY recently added by a55a9847, as the
corresponding section of config.sgml is now reverted.
Discussion: https://postgr.es/m/CAOuzzgrn7iKnFRsB4MHp3UisEQAGgZMbk_ViTN4HV4-Ksq8zCg%40mail.gmail.com
The upstream project is officially named "LZ4", and the documentation
was confused with the option value that can be used with DDLs supporting
this option, and the project name.
Documentation related to the configure option --with-lz4 was missing, so
add something for that.
Author: Dilip Kumar, Michael Paquier
Reviewed-by: Justin Pryzby
Discussion: https://postgr.es/m/YJaOZQDXBVySq+Cc@paquier.xyz
The docs mentioned expression indexes as a way to improve selectivity
estimates for functions, but we have a second option to improve that by
creating extended statistics. So mention that too.
Reported-by: Justin Pryzby
Discussion: https://postgr.es/m/20210505210947.GA27406%40telsasoft.com
The per-index collation version tracking feature was reverted, but we
still have the ability to ask Windows (352f6f2d) and FreeBSD
(ca051d8b) for collation versions to store in pg_collation.collversion.
So, from the reverted patch, take a few words of documentation about
libc on all three supported OSes to replace the pre-existing note that
mentioned only glibc.
Discussion: https://postgr.es/m/CA%2BhUKGLhj5t1fcjqAu8iD9B3ixJtsTNqyCCD4V0aTO9kAKAjjA%40mail.gmail.com
Design problems were discovered in the handling of composite types and
record types that would cause some relevant versions not to be recorded.
Misgivings were also expressed about the use of the pg_depend catalog
for this purpose. We're out of time for this release so we'll revert
and try again.
Commits reverted:
1bf946bd: Doc: Document known problem with Windows collation versions.
cf002008: Remove no-longer-relevant test case.
ef387bed: Fix bogus collation-version-recording logic.
0fb0a050: Hide internal error for pg_collation_actual_version(<bad OID>).
ff942057: Suppress "warning: variable 'collcollate' set but not used".
d50e3b1f: Fix assertion in collation version lookup.
f24b1569: Rethink extraction of collation dependencies.
257836a7: Track collation versions for indexes.
cd6f479e: Add pg_depend.refobjversion.
7d1297df: Remove pg_collation.collversion.
Discussion: https://postgr.es/m/CA%2BhUKGLhj5t1fcjqAu8iD9B3ixJtsTNqyCCD4V0aTO9kAKAjjA%40mail.gmail.com
The grammar changes in commit bbe0a81db69bd10bd166907c3701492a29aca294
allow SET COMPRESSION to be used with ALTER MATERIALIZED VIEW as
well as with ALTER TABLE, so update those docs to say that it works.
Also, update the documentation for the pg_column_compression()
to explain that it will return NULL when there's no relevant value.
Patch by me, per concerns from Michael Paquier.
Discussion: http://postgr.es/m/CA+Tgmob9h5u4iNL9KM0drZgkY-JL4oCVW0dWrMqtLPQ1zHkquA@mail.gmail.com
Currently, replication slot statistics are updated at prepare, commit, and
rollback. Now, if the transaction is interrupted the stats might not get
updated. Fixed this by updating replication statistics after every
stream/spill.
In passing update the docs to change the description of some of the slot
stats.
Author: Vignesh C, Sawada Masahiko
Reviewed-by: Amit Kapila
Discussion: https://postgr.es/m/20210319185247.ldebgpdaxsowiflw@alap3.anarazel.de
Previously, a lot of information about type regclass existed only
in the discussion of the sequence functions. Maybe that made sense
in the beginning, because I think originally those were the only
functions taking regclass. But it doesn't make sense anymore.
Move that material to the "Object Identifier Types" section in
datatype.sgml, generalize it to talk about the other reg* types
as well, and add more examples.
Per bug #16991 from Federico Caselli.
Discussion: https://postgr.es/m/16991-bcaeaafa17e0a723@postgresql.org
Before now, looking up "multirange" in the index only led to the
multirange() function. To make this more useful, also add an entry
pointing to the range types section.
Mention specifically that you can't call aggregates, window functions,
or procedures this way (the inability to call SRFs was already
mentioned).
Also, the claim that PQfn doesn't support NULL arguments or results
has been a lie since we invented protocol 3.0. Not sure why this
text was never updated for that, but do it now.
Discussion: https://postgr.es/m/2039442.1615317309@sss.pgh.pa.us
Makes partition descriptor acquisition faster during the transient
period in which a partition is in the process of being detached.
This also adds the restriction that only one partition can be in
pending-detach state for a partitioned table.
While at it, return find_inheritance_children() API to what it was
before 71f4c8c6f74b, and create a separate
find_inheritance_children_extended() that returns detailed info about
detached partitions.
(This incidentally fixes a bug in 8aba9322511 whereby a memory context
holding a transient partdesc is reparented to a NULL PortalContext,
leading to permanent leak of that memory. The fix is to no longer rely
on reparenting contexts to PortalContext. Reported by Amit Langote.)
Per gripe from Amit Langote
Discussion: https://postgr.es/m/CA+HiwqFgpP1LxJZOBYGt9rpvTjXXkg5qG2+Xch2Z1Q7KrqZR1A@mail.gmail.com
Commit 8ff1c94649 allowed TRUNCATE command to truncate foreign tables.
Previously the information about "ONLY" options specified in TRUNCATE
command were passed to the foreign data wrapper. Then postgres_fdw
constructed the TRUNCATE command to issue the remote server and
included "ONLY" options in it based on the passed information.
On the other hand, "ONLY" options specified in SELECT, UPDATE or DELETE
have no effect when accessing or modifying the remote table, i.e.,
are not passed to the foreign data wrapper. So it's inconsistent to
make only TRUNCATE command pass the "ONLY" options to the foreign data
wrapper. Therefore this commit changes the TRUNCATE command so that
it doesn't pass the "ONLY" options to the foreign data wrapper,
for the consistency with other statements. Also this commit changes
postgres_fdw so that it always doesn't include "ONLY" options in
the TRUNCATE command that it constructs.
Author: Fujii Masao
Reviewed-by: Bharath Rupireddy, Kyotaro Horiguchi, Justin Pryzby, Zhihong Yu
Discussion: https://postgr.es/m/551ed8c1-f531-818b-664a-2cecdab99cd8@oss.nttdata.com
For some reason, the "julian" option for extract()/date_part() has
never gotten listed in the manual. Also, while Appendix B mentioned
in passing that we don't conform to the usual astronomical definition
that a Julian date starts at noon UTC, it was kind of vague about what
we do instead. Clarify that, and add an example showing how to get
the astronomical definition if you want it.
It's been like this for ages, so back-patch to all supported branches.
Discussion: https://postgr.es/m/1197050.1619123213@sss.pgh.pa.us
