.TH "ATHDEBUG" "8" "February 2006" "" "" .SH "NAME" \fBathdebug\fP \- control the debug output from the madwifi device subsystem .SH "SYNOPSIS" .B athdebug [-i device] +/\- bitmap .SH "DESCRIPTION" Set and clear debug bitmaps for the madwifi ath device subsystem. Each argument is a bitmap or its alias. If a bitmap alias is used then it must be prefixed by either "-" to clear or "+" to set the corresponding bitmap. .PP All debugging output can be enabled with the 0xffffffff bitmap, while 0x0 disables all debug output. .PP .SH "OPTIONS" .TP .B \-? Display usage and list all debug flags. .TP .B \-i device The madwifi device to apply the settings to. If no interface is specified, \fBathdebug\fP defaults to wifi0. .TP .B +/\- bitmap Set (+) or clear (-) a debug flag. .PP .SH "BITMAP ALIASES" .BI xmit \- transmit of packets, just before they go out to the HW .br .BI xmit_desc \- transmit descriptors .br .BI recv \- received packets, directly from the HW .br .BI recv_desc \- recv descriptors .br .BI rate \- rate control modules .br .BI reset \- reset processing and inititalization .br .BI mode \- mode initialization and changes .br .BI beacon \- beacon handling .br .BI watchdog \- watchdog timeout .br .BI intr \- interrupt processing .br .BI xmit_proc \- processing of transmit descriptors .br .BI recv_proc \- processing of receive descriptors .br .BI beacon_proc \- beacon processing .br .BI calibrate \- periodic re-calibration .br .BI keycache \- key cache management .br .BI state \- 802.11 state transitions .br .BI node \- node management .BI ff \- fast frame handling .br .BI fatal fatal errors .br .PP .SH "EXAMPLES" .TP .B athdebug \-i wifi1 0xffffffff Enable all debug bitmaps on wifi1. .TP .B athdebug +rate Enable rate debug bitmap on wifi0. .TP .B athdebug \-rate Clear rate bitmap on wifi0. .PP .SH "SEE ALSO" \fB80211debug\fP(8), \fBhttp://madwifi-project.org/wiki/DevDocs/AthDebug\fP .SH "AUTHOR" This manual page was written by Kel Modderman and was based upon previous text written by Eric S. Raymond.