/* * This software is distributed under the terms of the * GNU General Public License ("GPL") version 2 as published by the Free * Software Foundation. * * NO WARRANTY * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT * LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY * AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL * THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, * OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER * IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF * THE POSSIBILITY OF SUCH DAMAGES. * * $Id: if_ath_radar.h 2464 2007-06-15 22:51:56Z mtaylor $ */ /* * Defintions for the Atheros Wireless LAN controller driver. */ #ifndef _IF_ATH_RADAR_H #define _IF_ATH_RADAR_H /* AR5K_AR5212_PHY_ERR_FIL register definition taken from openhal */ #define AR5K_AR5212_PHY_ERR_FIL 0x810c #define AR5K_AR5212_PHY_ERR_FIL_RADAR 0x00000020 /* AR5K_PHY_RADAR register definition reverse engineered with * ATH_REVERSE_ENGINEERING. */ /* PHY radar detection register [5111+] */ #define AR5K_PHY_RADAR 0x9954 /* Radar enable ........ ........ ........ .......1 */ #define AR5K_PHY_RADAR_ENABLE 0x00000001 #define AR5K_PHY_RADAR_ENABLE_S 0 /* This is the value found on the card .1.111.1 .1.1.... 111....1 1...1... at power on. */ #define AR5K_PHY_RADAR_PWONDEF_AR5213 0x5d50e188 /* This is the value found on the card .1.1.111 ..11...1 .1...1.1 1...11.1 after DFS is enabled */ #define AR5K_PHY_RADAR_ENABLED_AR5213 0x5731458d /* Finite Impulse Response (FIR) filter .1111111 ........ ........ ........ * power out threshold. * 7-bits signed integer, standard power range {-63..63} in 1 dBm units. */ #define AR5K_PHY_RADAR_FIRPWROUTTHR 0x7f000000 #define AR5K_PHY_RADAR_FIRPWROUTTHR_S 24 /* Radar RSSI/SNR threshold. ........ 111111.. ........ ........ * 6-bits unsigned integer, 1 dBm, range {0..63} in dBm units. */ #define AR5K_PHY_RADAR_RADARRSSITHR 0x00fc0000 #define AR5K_PHY_RADAR_RADARRSSITHR_S 18 /* Pulse height threshold ........ ......11 1111.... ........ * 6-bits unsigned integer, 1 dBm, range {0..63} in dBm units. */ #define AR5K_PHY_RADAR_PULSEHEIGHTTHR 0x0003f000 #define AR5K_PHY_RADAR_PULSEHEIGHTTHR_S 12 /* Pulse RSSI/SNR threshold ........ ........ ....1111 11...... * 6-bits unsigned integer, 1 dBm, range {0..63} in dBm units. */ #define AR5K_PHY_RADAR_PULSERSSITHR 0x00000fc0 #define AR5K_PHY_RADAR_PULSERSSITHR_S 6 /* Inband threshold ........ ........ ........ ..11111. * 5-bits unsigned integer, 1/2 dBm, range {0..31} in 0.5 dBm units */ #define AR5K_PHY_RADAR_INBANDTHR 0x0000003e #define AR5K_PHY_RADAR_INBANDTHR_S 1 /* This struct defines the supported PHY error detection parameters for radar * pulse detection logic. Reference US patent US6891496 B2 for pseudocode for * the chips' operations and pseudocode for how the parameters are used. */ typedef struct { /* Finite Impulse Response (FIR) filter - power out threshold. * * If a signal is received with a pulse width that is too short, * the AR chip cannot fine-adjust gain fast enough to get an accurate * reading of RSSI. If this signal has an power value after filtering * that exceeds a fixed threshold (rp_fir_filter_output_power_thr) * and then drops by rp_pulse_height_thr then it may be considered a * radar pulse. * * Reference: 405 in Figure 4A of US patent US6891496 B2. * Default: Default value is -41dBm. * Units: Signed integer, value in dBm {-63..63} in 1 dBm units. */ int32_t rp_fir_filter_output_power_thr; /* Pulse height threshold * This is delta between the max and min RSSI for short pulse radar * bursts where AGC cannot be adjusted enough times to get an accurate * sizing of the pulse. * * If a signal is received with a pulse width that is too short, * the AR chip cannot fine-adjust gain fast enough to get an accurate * reading of RSSI. If this signal has an power value after filtering * that exceeds a fixed threshold (rp_fir_filter_output_power_thr) * and then drops by rp_pulse_height_thr then it may be considered a * radar pulse. * * Refernece: See Figure 4A. * Default: value is 20 dBm. * Units: Unsigned 6-bits, dBm range {0..63} in dBm units. */ int32_t rp_pulse_height_thr; /* Radar RSSI/SNR threshold. * * This is the threshold that RSSI must exceed for the pulse when AGC * is ok and we actually know the power of the signal (not the chip) * and reach an initial peak greater than this threshold. * * For pulses long enough for AGC to be used to detect * pulse width (approximately >3us), we will start counting the pulse * width if it reaches this level as this may be the rise of a radar * pulse. * * Reference: See 450 on Figure 4B in US patent US6891496 B2. * Default: value is 12, or 6 dBm. * Units: 6-bits, dBm range {0..63} in dBm units. */ int32_t rp_radar_rssi_thr; /* Pulse RSSI/SNR threshold * * This is how much the RSSI of the pulse must drop, relative to * rp_radar_rssi_thr before we will stop counting the pulse width. * * If we see a pulse reach rp_radar_rssi_thr we start thinking it might * be radar, but if it subsequently reached * (rp_radar_rssi_thr - rp_pulse_height_thr) and it wasn't part of a * WLAN signal, then we would know it was radar. * * In other words, we are looking for a 6dBm drop in gain that happens * after a pulse on the down swing as shown in figure 4A and 4B. * * Default: 22, or 11 dBm. * Units: Unsigned 6-bits, dBm range {0..63} in dBm units. */ int32_t rp_pulse_rssi_thr; /* Inband threshold. * Units: Unsigned 5-bits, dBm range {0..31} in half dBm units. */ int32_t rp_inband_thr; } RADAR_PARAM; /* Any value in RADAR_PARAM can be set to this magic value in order to use the default for that field */ #define RADAR_PARAM_USE_DEFAULT 0xffff /* This is called on channel change to enable radar detection for 5211+ chips. * NOTE: AR5210 doesn't have radar pulse detection support. */ int ath_radar_update(struct ath_softc *sc); /* Returns true if radar detection is enabled. */ int ath_radar_is_enabled(struct ath_softc *sc); /* Read the radar pulse detection parameters. */ void ath_radar_get_params(struct ath_softc *sc, RADAR_PARAM* rp); /* Update the radar pulse detection parameters. * If rp is NULL, defaults are used for all fields. * If any member of rp is set to RADAR_PARAM_USE_DEFAULT, the default * is used for that field. */ void ath_radar_set_params(struct ath_softc *sc, RADAR_PARAM* rp); /* Update channel's DFS flags based upon whether DFS is reqired */ int ath_radar_correct_dfs_flags(struct ath_softc *sc, HAL_CHANNEL *hchan); /* Returns true if DFS is required for the regulatory domain, country and * combination in use. */ int ath_radar_is_dfs_required(struct ath_softc *sc, HAL_CHANNEL *hchan); /* Maximum number of radar pulse recorded */ #define ATH_RADAR_PULSE_NR 100 /* init/done function for radar pulse stuff */ void ath_rp_init(struct ath_softc *sc); void ath_rp_done(struct ath_softc *sc); /* Record a radar pulse event in a circular array */ void ath_rp_record(struct ath_softc *sc, u_int64_t tsf, u_int8_t rssi, u_int8_t width, HAL_BOOL is_simulated); /* Print the content of the radar pulse circular array */ void ath_rp_print(struct ath_softc *sc, int analyzed_pulses_only); void ath_rp_print_mem(struct ath_softc *sc, int analyzed_pulses_only); /* Empty the radar pulse circular array */ void ath_rp_flush(struct ath_softc *sc); #endif /* #ifndef _IF_ATH_RADAR_H */