///////////////////////////////////////////////////////////////////////// // $Id$ ///////////////////////////////////////////////////////////////////////// // // Copyright (C) 2001-2017 The Bochs Project // // This library is free software; you can redistribute it and/or // modify it under the terms of the GNU Lesser General Public // License as published by the Free Software Foundation; either // version 2 of the License, or (at your option) any later version. // // This library is distributed in the hope that it will be useful, // but WITHOUT ANY WARRANTY; without even the implied warranty of // MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU // Lesser General Public License for more details. // // You should have received a copy of the GNU Lesser General Public // License along with this library; if not, write to the Free Software // Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA // Peter Grehan (grehan@iprg.nokia.com) coded all of this // NE2000/ether stuff. // // An implementation of an ne2000 ISA ethernet adapter. This part uses // a National Semiconductor DS-8390 ethernet MAC chip, with some h/w // to provide a windowed memory region for the chip and a MAC address. // #ifndef BX_IODEV_NE2K #define BX_IODEV_NE2K #if BX_USE_NE2K_SMF # define BX_NE2K_SMF static # define BX_NE2K_THIS theNE2kDevice-> # define BX_NE2K_THIS_PTR theNE2kDevice #else # define BX_NE2K_SMF # define BX_NE2K_THIS this-> # define BX_NE2K_THIS_PTR this #endif #define BX_NE2K_MEMSIZ (32*1024) #define BX_NE2K_MEMSTART (16*1024) #define BX_NE2K_MEMEND (BX_NE2K_MEMSTART + BX_NE2K_MEMSIZ) class eth_pktmover_c; typedef struct { // // ne2k register state // // Page 0 // // Command Register - 00h read/write struct { bx_bool stop; // STP - Software Reset command bx_bool start; // START - start the NIC bx_bool tx_packet; // TXP - initiate packet transmission Bit8u rdma_cmd; // RD0,RD1,RD2 - Remote DMA command Bit8u pgsel; // PS0,PS1 - Page select } CR; // Interrupt Status Register - 07h read/write struct { bx_bool pkt_rx; // PRX - packet received with no errors bx_bool pkt_tx; // PTX - packet transmitted with no errors bx_bool rx_err; // RXE - packet received with 1 or more errors bx_bool tx_err; // TXE - packet tx'd " " " " " bx_bool overwrite; // OVW - rx buffer resources exhausted bx_bool cnt_oflow; // CNT - network tally counter MSB's set bx_bool rdma_done; // RDC - remote DMA complete bx_bool reset; // RST - reset status } ISR; // Interrupt Mask Register - 0fh write struct { bx_bool rx_inte; // PRXE - packet rx interrupt enable bx_bool tx_inte; // PTXE - packet tx interrput enable bx_bool rxerr_inte; // RXEE - rx error interrupt enable bx_bool txerr_inte; // TXEE - tx error interrupt enable bx_bool overw_inte; // OVWE - overwrite warn int enable bx_bool cofl_inte; // CNTE - counter o'flow int enable bx_bool rdma_inte; // RDCE - remote DMA complete int enable bx_bool reserved; // D7 - reserved } IMR; // Data Configuration Register - 0eh write struct { bx_bool wdsize; // WTS - 8/16-bit select bx_bool endian; // BOS - byte-order select bx_bool longaddr; // LAS - long-address select bx_bool loop; // LS - loopback select bx_bool auto_rx; // AR - auto-remove rx packets with remote DMA Bit8u fifo_size; // FT0,FT1 - fifo threshold } DCR; // Transmit Configuration Register - 0dh write struct { bx_bool crc_disable; // CRC - inhibit tx CRC Bit8u loop_cntl; // LB0,LB1 - loopback control bx_bool ext_stoptx; // ATD - allow tx disable by external mcast bx_bool coll_prio; // OFST - backoff algorithm select Bit8u reserved; // D5,D6,D7 - reserved } TCR; // Transmit Status Register - 04h read struct { bx_bool tx_ok; // PTX - tx complete without error bx_bool reserved; // D1 - reserved bx_bool collided; // COL - tx collided >= 1 times bx_bool aborted; // ABT - aborted due to excessive collisions bx_bool no_carrier; // CRS - carrier-sense lost bx_bool fifo_ur; // FU - FIFO underrun bx_bool cd_hbeat; // CDH - no tx cd-heartbeat from transceiver bx_bool ow_coll; // OWC - out-of-window collision } TSR; // Receive Configuration Register - 0ch write struct { bx_bool errors_ok; // SEP - accept pkts with rx errors bx_bool runts_ok; // AR - accept < 64-byte runts bx_bool broadcast; // AB - accept eth broadcast address bx_bool multicast; // AM - check mcast hash array bx_bool promisc; // PRO - accept all packets bx_bool monitor; // MON - check pkts, but don't rx Bit8u reserved; // D6,D7 - reserved } RCR; // Receive Status Register - 0ch read struct { bx_bool rx_ok; // PRX - rx complete without error bx_bool bad_crc; // CRC - Bad CRC detected bx_bool bad_falign; // FAE - frame alignment error bx_bool fifo_or; // FO - FIFO overrun bx_bool rx_missed; // MPA - missed packet error bx_bool rx_mbit; // PHY - unicast or mcast/bcast address match bx_bool rx_disabled; // DIS - set when in monitor mode bx_bool deferred; // DFR - collision active } RSR; Bit16u local_dma; // 01,02h read ; current local DMA addr Bit8u page_start; // 01h write ; page start register Bit8u page_stop; // 02h write ; page stop register Bit8u bound_ptr; // 03h read/write ; boundary pointer Bit8u tx_page_start; // 04h write ; transmit page start register Bit8u num_coll; // 05h read ; number-of-collisions register Bit16u tx_bytes; // 05,06h write ; transmit byte-count register Bit8u fifo; // 06h read ; FIFO Bit16u remote_dma; // 08,09h read ; current remote DMA addr Bit16u remote_start; // 08,09h write ; remote start address register Bit16u remote_bytes; // 0a,0bh write ; remote byte-count register Bit8u tallycnt_0; // 0dh read ; tally counter 0 (frame align errors) Bit8u tallycnt_1; // 0eh read ; tally counter 1 (CRC errors) Bit8u tallycnt_2; // 0fh read ; tally counter 2 (missed pkt errors) // // Page 1 // // Command Register 00h (repeated) // Bit8u physaddr[6]; // 01-06h read/write ; MAC address Bit8u curr_page; // 07h read/write ; current page register Bit8u mchash[8]; // 08-0fh read/write ; multicast hash array // // Page 2 - diagnostic use only // // Command Register 00h (repeated) // // Page Start Register 01h read (repeated) // Page Stop Register 02h read (repeated) // Current Local DMA Address 01,02h write (repeated) // Transmit Page start address 04h read (repeated) // Receive Configuration Register 0ch read (repeated) // Transmit Configuration Register 0dh read (repeated) // Data Configuration Register 0eh read (repeated) // Interrupt Mask Register 0fh read (repeated) // Bit8u rempkt_ptr; // 03h read/write ; remote next-packet pointer Bit8u localpkt_ptr; // 05h read/write ; local next-packet pointer Bit16u address_cnt; // 06,07h read/write ; address counter // // Page 3 - should never be modified. // // Novell ASIC state Bit8u macaddr[32]; // ASIC ROM'd MAC address, even bytes Bit8u mem[BX_NE2K_MEMSIZ]; // on-chip packet memory // ne2k internal state Bit32u base_address; int base_irq; int tx_timer_index; bx_bool tx_timer_active; int statusbar_id; // pci stuff bx_bool pci_enabled; #if BX_SUPPORT_PCI Bit8u devfunc; #endif } bx_ne2k_t; class bx_ne2k_c #if BX_SUPPORT_PCI : public bx_pci_device_c #else : public bx_devmodel_c #endif { public: bx_ne2k_c(); virtual ~bx_ne2k_c(); virtual void init(void); virtual void reset(unsigned type); virtual void register_state(void); #if BX_SUPPORT_PCI virtual void after_restore_state(void); #endif #if BX_DEBUGGER virtual void debug_dump(int argc, char **argv); #endif #if BX_SUPPORT_PCI virtual void pci_write_handler(Bit8u address, Bit32u value, unsigned io_len); #endif private: bx_ne2k_t s; eth_pktmover_c *ethdev; BX_NE2K_SMF Bit32u read_cr(void); BX_NE2K_SMF void write_cr(Bit32u value); BX_NE2K_SMF void set_irq_level(bx_bool level); BX_NE2K_SMF Bit32u chipmem_read(Bit32u address, unsigned io_len) BX_CPP_AttrRegparmN(2); BX_NE2K_SMF Bit32u asic_read(Bit32u offset, unsigned io_len) BX_CPP_AttrRegparmN(2); BX_NE2K_SMF Bit32u page0_read(Bit32u offset, unsigned io_len); BX_NE2K_SMF Bit32u page1_read(Bit32u offset, unsigned io_len); BX_NE2K_SMF Bit32u page2_read(Bit32u offset, unsigned io_len); BX_NE2K_SMF Bit32u page3_read(Bit32u offset, unsigned io_len); BX_NE2K_SMF void chipmem_write(Bit32u address, Bit32u value, unsigned io_len) BX_CPP_AttrRegparmN(3); BX_NE2K_SMF void asic_write(Bit32u address, Bit32u value, unsigned io_len); BX_NE2K_SMF void page0_write(Bit32u address, Bit32u value, unsigned io_len); BX_NE2K_SMF void page1_write(Bit32u address, Bit32u value, unsigned io_len); BX_NE2K_SMF void page2_write(Bit32u address, Bit32u value, unsigned io_len); BX_NE2K_SMF void page3_write(Bit32u address, Bit32u value, unsigned io_len); static void tx_timer_handler(void *); BX_NE2K_SMF void tx_timer(void); static Bit32u rx_status_handler(void *arg); BX_NE2K_SMF Bit32u rx_status(void); static void rx_handler(void *arg, const void *buf, unsigned len); BX_NE2K_SMF unsigned mcast_index(const void *dst); BX_NE2K_SMF void rx_frame(const void *buf, unsigned io_len); #if BX_SUPPORT_PCI BX_NE2K_SMF bx_bool mem_read_handler(bx_phy_address addr, unsigned len, void *data, void *param); #endif static Bit32u read_handler(void *this_ptr, Bit32u address, unsigned io_len); static void write_handler(void *this_ptr, Bit32u address, Bit32u value, unsigned io_len); #if !BX_USE_NE2K_SMF Bit32u read(Bit32u address, unsigned io_len); void write(Bit32u address, Bit32u value, unsigned io_len); #endif #if BX_DEBUGGER void print_info(int page, int reg, int nodups); #endif }; #endif