NetBSD/sys/dev/podulebus/if_eireg.h

68 lines
2.0 KiB
C

/* $NetBSD: if_eireg.h,v 1.2 2001/12/21 22:33:28 bjh21 Exp $ */
/*
* 2000 Ben Harris
*
* This file is in the public domain.
*/
/*
* if_eireg.h - register definitions etc for the Acorn Ether1 card
*/
#ifndef _IF_EIREG_H_
#define _IF_EIREG_H_
/*
* The card has three address spaces. The ROM is mapped into the
* bottom 32 bytes of SYNC address space, and contains the
* expansion card ID information and the Ethernet address. There is a
* pair of write-only registers at the start of the FAST address
* space. One of these performs miscellaneous control functions, and
* the other acts as a page selector for the board memory. The board
* has 64k of RAM, and 4k pages of this can be mapped at offset 0x2000
* in the FAST space by writing the page number to the page register.
* The 82586 has access to the whole of this memory and (I believe)
* sees it as the top 64k of its address space.
*/
/* Registers in the board's control space */
#define EI_PAGE 0
#define EI_CONTROL 1
#define EI_CTL_RST 0x01 /* Reset */
#define EI_CTL_LB 0x02 /* Loop-back */
#define EI_CTL_CA 0x04 /* Channel Attention */
#define EI_CTL_CLI 0x08 /* Clear Interrupt */
/* Offset of base of memory in bus_addr_t units */
#define EI_MEMOFF 0x2000
/*
* All addresses within board RAM are in bytes of actual RAM. RAM is
* 16 bits wide, and can only be accessed by word transfers
* (bus_space_xxx_2).
*/
#define EI_MEMSIZE 0x10000
#define EI_MEMBASE (0x1000000 - EI_MEMSIZE)
#define EI_PAGESIZE 0x1000
#define EI_NPAGES (EI_MEMSIZE / EI_PAGESIZE)
#define ei_atop(a) (((a) % EI_MEMSIZE) / EI_PAGESIZE)
#define ei_atopo(a) ((a) % EI_PAGESIZE)
#define EI_SCP_ADDR IE_SCP_ADDR % EI_MEMSIZE
/*
* The ROM on the Ether1 is a bit oddly wired, in that the interrupt
* line is wired up as the high-order address line, so as to allow the
* interrupt status bit the the first byte to reflect the actual
* interrupt status.
*/
#define EI_ROMSIZE 0x20
/* First eight bytes are standard extended podule ID. */
#define EI_ROM_HWREV 0x08
#define EI_ROM_EADDR 0x09
#define EI_ROM_CRC 0x1c
#endif