NetBSD/sys/dev/mii/dmphyreg.h

82 lines
3.8 KiB
C

/* $NetBSD: dmphyreg.h,v 1.2 2008/04/28 20:23:53 martin Exp $ */
/*-
* Copyright (c) 2000 The NetBSD Foundation, Inc.
* All rights reserved.
*
* This code is derived from software contributed to The NetBSD Foundation
* by Jason R. Thorpe of the Numerical Aerospace Simulation Facility,
* NASA Ames Research Center.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
* TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
* PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
* BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
* CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
* CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*/
#ifndef _DEV_MII_DMPHYREG_H_
#define _DEV_MII_DMPHYREG_H_
/*
* Davicom DM9101 registers.
*/
#define MII_DMPHY_DSCR 0x10 /* DAVICOM Specified Config Reg */
#define DSCR_BP_4B5B 0x8000 /* bypass 4b5b encoding/decoding */
#define DSCR_SCR 0x4000 /* bypass scrambler/descrambler */
#define DSCR_ALIGN 0x2000 /* bypass symbol alignment */
#define DSCR_REPEATER 0x0800 /* repeater mode */
#define DSCR_TX 0x0400 /* 1 == 100baseTX, 0 == 100baseFX */
#define DSCR_UTP 0x0200 /* 1 == UTP, 0 == STP */
#define DSCR_CLK25MDIS 0x0100 /* CLK25M disable */
#define DSCR_F_LINK_100 0x0080 /* force good link in 100Mb/s mode */
#define DSCR_LINKLED_CTL 0x0020 /* 1 == link only, 0 == link+traffic */
#define DSCR_FDXLEN_MODE 0x0010 /* 1 == 10baseT polarity, 0 == FDX */
#define DSCR_SMRST 0x0008 /* reset state machine */
#define DSCR_MFPSC 0x0004 /* MF preamble suppression */
#define DSCR_SLEEP 0x0002 /* sleep mode */
#define DSCR_RLOUT 0x0001 /* remote loop-out control */
#define MII_DMPHY_DSCSR 0x11 /* DAVICOM Spec'd Conf/Stat Reg */
#define DSCSR_100FDX 0x8000 /* 100Mb/s FDX */
#define DSCSR_100HDX 0x4000 /* 100Mb/s HDX */
#define DSCSR_10FDX 0x2000 /* 10Mb/s FDX */
#define DSCSR_10HDX 0x1000 /* 10Mb/s HDX */
#define DSCSR_PHYAD 0x01f0 /* PHY address */
#define DSCSR_ANMB 0x000f /* Autonegotiation monitor */
#define ANMB_IDLE 0x0000 /* idle */
#define ANMB_AB_MATCH 0x0001 /* ability match */
#define ANMB_ACK_MATCH 0x0002 /* acknowledge match */
#define ANMB_ACK_MATCH_FAIL 0x0003 /* acknowledge match fail */
#define ANMB_CON_MATCH 0x0004 /* consistency match */
#define ANMB_CON_MATCH_FAIL 0x0005 /* consistency match fail */
#define ANMB_PAR_LINK 0x0006 /* par detect signal link ready */
#define ANMB_PAR_LINK_FAIL 0x0007 /* par detect signal link ready fail */
#define ANMB_ANEG_OK 0x0008 /* autonegotiation completed ok */
#define MII_DMPHY_BTCSR 0x12 /* 10baseT Configuration/Status */
#define BTCSR_LP_EN 0x4000 /* link pulse enable */
#define BTCSR_HBE 0x2000 /* heartbeat enable */
#define BTCSR_JABEN 0x0800 /* jabber enable */
#define BTCSR_10BT_SER 0x0400 /* 10baseT serial mode */
#define BTCSR_POLR 0x0001 /* polarity reversed */
#endif /* _DEV_MII_DMPHYREG_H_ */