232 lines
6.2 KiB
C
232 lines
6.2 KiB
C
/* $NetBSD: if_wereg.h,v 1.1 1997/11/03 21:22:50 thorpej Exp $ */
|
|
|
|
/*
|
|
* National Semiconductor DS8390 NIC register definitions.
|
|
*
|
|
* Copyright (C) 1993, David Greenman. This software may be used, modified,
|
|
* copied, distributed, and sold, in both source and binary form provided that
|
|
* the above copyright and these terms are retained. Under no circumstances is
|
|
* the author responsible for the proper functioning of this software, nor does
|
|
* the author assume any responsibility for damages incurred with its use.
|
|
*/
|
|
|
|
/*
|
|
* Compile-time config flags
|
|
*/
|
|
/*
|
|
* This sets the default for enabling/disablng the tranceiver.
|
|
*/
|
|
#define WE_FLAGS_DISABLE_TRANCEIVER 0x0001
|
|
|
|
/*
|
|
* This forces the board to be used in 8/16-bit mode even if it autoconfigs
|
|
* differently.
|
|
*/
|
|
#define WE_FLAGS_FORCE_8BIT_MODE 0x0002
|
|
#define WE_FLAGS_FORCE_16BIT_MODE 0x0004
|
|
|
|
/*
|
|
* This disables the use of double transmit buffers.
|
|
*/
|
|
#define WE_FLAGS_NO_MULTI_BUFFERING 0x0008
|
|
|
|
/*
|
|
* Definitions for Western digital/SMC WD80x3 series ASIC
|
|
*/
|
|
|
|
/*
|
|
* Memory Select Register (MSR)
|
|
*/
|
|
#define WE_MSR 0
|
|
|
|
/* next three definitions for Toshiba */
|
|
#define WE_MSR_POW 0x02 /* 0 = power save, 1 = normal (R/W) */
|
|
#define WE_MSR_BSY 0x04 /* gate array busy (R) */
|
|
#define WE_MSR_LEN 0x20 /* 0 = 16-bit, 1 = 8-bit (R/W) */
|
|
|
|
#define WE_MSR_ADDR 0x3f /* Memory decode bits 18-13 */
|
|
#define WE_MSR_MENB 0x40 /* Memory enable */
|
|
#define WE_MSR_RST 0x80 /* Reset board */
|
|
|
|
/*
|
|
* Interface Configuration Register (ICR)
|
|
*/
|
|
#define WE_ICR 1
|
|
|
|
#define WE_ICR_16BIT 0x01 /* 16-bit interface */
|
|
#define WE_ICR_OAR 0x02 /* select register (0=BIO 1=EAR) */
|
|
#define WE_ICR_IR2 0x04 /* high order bit of encoded IRQ */
|
|
#define WE_ICR_MSZ 0x08 /* memory size (0=8k 1=32k) */
|
|
#define WE_ICR_RLA 0x10 /* recall LAN address */
|
|
#define WE_ICR_RX7 0x20 /* recall all but i/o and LAN address */
|
|
#define WE_ICR_RIO 0x40 /* recall i/o address */
|
|
#define WE_ICR_STO 0x80 /* store to non-volatile memory */
|
|
#ifdef TOSH_ETHER
|
|
#define WE_ICR_MEM 0xe0 /* shared mem address A15-A13 (R/W) */
|
|
#define WE_ICR_MSZ1 0x0f /* memory size, 0x08 = 64K, 0x04 = 32K,
|
|
0x02 = 16K, 0x01 = 8K */
|
|
/* 64K can only be used if mem address
|
|
above 1MB */
|
|
/* IAR holds address A23-A16 (R/W) */
|
|
#endif
|
|
|
|
/*
|
|
* IO Address Register (IAR)
|
|
*/
|
|
#define WE_IAR 2
|
|
|
|
/*
|
|
* EEROM Address Register
|
|
*/
|
|
#define WE_EAR 3
|
|
|
|
/*
|
|
* Interrupt Request Register (IRR)
|
|
*/
|
|
#define WE_IRR 4
|
|
|
|
#define WE_IRR_0WS 0x01 /* use 0 wait-states on 8 bit bus */
|
|
#define WE_IRR_OUT1 0x02 /* WD83C584 pin 1 output */
|
|
#define WE_IRR_OUT2 0x04 /* WD83C584 pin 2 output */
|
|
#define WE_IRR_OUT3 0x08 /* WD83C584 pin 3 output */
|
|
#define WE_IRR_FLASH 0x10 /* Flash RAM is in the ROM socket */
|
|
|
|
/*
|
|
* The three bits of the encoded IRQ are decoded as follows:
|
|
*
|
|
* IR2 IR1 IR0 IRQ
|
|
* 0 0 0 2/9
|
|
* 0 0 1 3
|
|
* 0 1 0 5
|
|
* 0 1 1 7
|
|
* 1 0 0 10
|
|
* 1 0 1 11
|
|
* 1 1 0 15
|
|
* 1 1 1 4
|
|
*/
|
|
#define WE_IRR_IR0 0x20 /* bit 0 of encoded IRQ */
|
|
#define WE_IRR_IR1 0x40 /* bit 1 of encoded IRQ */
|
|
#define WE_IRR_IEN 0x80 /* Interrupt enable */
|
|
|
|
/*
|
|
* LA Address Register (LAAR)
|
|
*/
|
|
#define WE_LAAR 5
|
|
|
|
#define WE_LAAR_ADDRHI 0x1f /* bits 23-19 of RAM address */
|
|
#define WE_LAAR_0WS16 0x20 /* enable 0 wait-states on 16 bit bus */
|
|
#define WE_LAAR_L16EN 0x40 /* enable 16-bit operation */
|
|
#define WE_LAAR_M16EN 0x80 /* enable 16-bit memory access */
|
|
|
|
/* i/o base offset to station address/card-ID PROM */
|
|
#define WE_PROM 8
|
|
|
|
/*
|
|
* 83C790 specific registers
|
|
*/
|
|
/*
|
|
* Hardware Support Register (HWR) ('790)
|
|
*/
|
|
#define WE790_HWR 4
|
|
|
|
#define WE790_HWR_RST 0x10 /* hardware reset */
|
|
#define WE790_HWR_LPRM 0x40 /* LAN PROM select */
|
|
#define WE790_HWR_SWH 0x80 /* switch register set */
|
|
|
|
/*
|
|
* ICR790 Interrupt Control Register for the 83C790
|
|
*/
|
|
#define WE790_ICR 6
|
|
|
|
#define WE790_ICR_EIL 0x01 /* enable interrupts */
|
|
|
|
/*
|
|
* REV/IOPA Revision / I/O Pipe register for the 83C79X
|
|
*/
|
|
#define WE790_REV 7
|
|
|
|
#define WE790_REV_790 0x20
|
|
#define WE790_REV_795 0x40
|
|
|
|
/*
|
|
* 79X RAM Address Register (RAR)
|
|
* Enabled with SWH bit=1 in HWR register
|
|
*/
|
|
|
|
#define WE790_RAR 0x0b
|
|
|
|
#define WE790_RAR_SZ8 0x00 /* 8k memory buffer */
|
|
#define WE790_RAR_SZ16 0x10 /* 16k memory buffer */
|
|
#define WE790_RAR_SZ32 0x20 /* 32k memory buffer */
|
|
#define WE790_RAR_SZ64 0x30 /* 64k memory buffer */
|
|
|
|
/*
|
|
* General Control Register (GCR)
|
|
* Eanbled with SWH bit == 1 in HWR register
|
|
*/
|
|
#define WE790_GCR 0x0d
|
|
|
|
#define WE790_GCR_LIT 0x01 /* on for UTP */
|
|
#define WE790_GCR_GPOUT 0x02 /* if BNC is enabled */
|
|
#define WE790_GCR_IR0 0x04 /* bit 0 of encoded IRQ */
|
|
#define WE790_GCR_IR1 0x08 /* bit 1 of encoded IRQ */
|
|
#define WE790_GCR_ZWSEN 0x20 /* zero wait state enable */
|
|
#define WE790_GCR_IR2 0x40 /* bit 2 of encoded IRQ */
|
|
/*
|
|
* The three bits of the encoded IRQ are decoded as follows:
|
|
*
|
|
* IR2 IR1 IR0 IRQ
|
|
* 0 0 0 none
|
|
* 0 0 1 9
|
|
* 0 1 0 3
|
|
* 0 1 1 5
|
|
* 1 0 0 7
|
|
* 1 0 1 10
|
|
* 1 1 0 11
|
|
* 1 1 1 15
|
|
*/
|
|
|
|
/* i/o base offset to CARD ID */
|
|
#define WE_CARD_ID WE_PROM+6
|
|
|
|
/* Board type codes in card ID */
|
|
#define WE_TYPE_WD8003S 0x02
|
|
#define WE_TYPE_WD8003E 0x03
|
|
#define WE_TYPE_WD8013EBT 0x05
|
|
#define WE_TYPE_TOSHIBA1 0x11 /* named PCETA1 */
|
|
#define WE_TYPE_TOSHIBA2 0x12 /* named PCETA2 */
|
|
#define WE_TYPE_TOSHIBA3 0x13 /* named PCETB */
|
|
#define WE_TYPE_TOSHIBA4 0x14 /* named PCETC */
|
|
#define WE_TYPE_WD8003W 0x24
|
|
#define WE_TYPE_WD8003EB 0x25
|
|
#define WE_TYPE_WD8013W 0x26
|
|
#define WE_TYPE_WD8013EP 0x27
|
|
#define WE_TYPE_WD8013WC 0x28
|
|
#define WE_TYPE_WD8013EPC 0x29
|
|
#define WE_TYPE_SMC8216T 0x2a
|
|
#define WE_TYPE_SMC8216C 0x2b
|
|
#define WE_TYPE_WD8013EBP 0x2c
|
|
|
|
/* Bit definitions in card ID */
|
|
#define WE_REV_MASK 0x1f /* Revision mask */
|
|
#define WE_SOFTCONFIG 0x20 /* Soft config */
|
|
#define WE_LARGERAM 0x40 /* Large RAM */
|
|
#define WE_MICROCHANEL 0x80 /* Microchannel bus (vs. isa) */
|
|
|
|
/*
|
|
* Checksum total. All 8 bytes in station address PROM will add up to this.
|
|
*/
|
|
#ifdef TOSH_ETHER
|
|
#define WE_ROM_CHECKSUM_TOTAL 0xA5
|
|
#else
|
|
#define WE_ROM_CHECKSUM_TOTAL 0xFF
|
|
#endif
|
|
|
|
#define WE_NIC_OFFSET 0x10 /* I/O base offset to NIC */
|
|
#define WE_ASIC_OFFSET 0 /* I/O base offset to ASIC */
|
|
#define WE_NIC_NPORTS 16
|
|
#define WE_ASIC_NPORTS 16
|
|
#define WE_NPORTS (WE_NIC_NPORTS + WE_ASIC_NPORTS)
|
|
|
|
#define WE_PAGE_OFFSET 0 /* page offset for NIC access to mem */
|