111 lines
4.9 KiB
C
111 lines
4.9 KiB
C
/*-
|
|
* Copyright (c) 2006 Sam Leffler, Errno Consulting, Atheros
|
|
* Communications, Inc. All rights reserved.
|
|
*
|
|
* Redistribution and use in source and binary forms are permitted
|
|
* provided that the following conditions are met:
|
|
* 1. The materials contained herein are unmodified and are used
|
|
* unmodified.
|
|
* 2. Redistributions of source code must retain the above copyright
|
|
* notice, this list of conditions and the following NO
|
|
* ''WARRANTY'' disclaimer below (''Disclaimer''), without
|
|
* modification.
|
|
* 3. Redistributions in binary form must reproduce at minimum a
|
|
* disclaimer similar to the Disclaimer below and any redistribution
|
|
* must be conditioned upon including a substantially similar
|
|
* Disclaimer requirement for further binary redistribution.
|
|
* 4. Neither the names of the above-listed copyright holders nor the
|
|
* names of any contributors may be used to endorse or promote
|
|
* product derived from this software without specific prior written
|
|
* permission.
|
|
*
|
|
* NO WARRANTY
|
|
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
|
|
* ''AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
|
|
* LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT,
|
|
* MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
|
|
* IN NO EVENT SHALL THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE
|
|
* FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
|
|
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
|
|
* USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND
|
|
* ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
|
|
* OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT
|
|
* OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
|
|
* SUCH DAMAGES.
|
|
*
|
|
* $Id: ah_soc.h,v 1.1 2006/06/07 06:43:36 gdamore Exp $
|
|
*/
|
|
#ifndef _ATH_AH_SOC_H_
|
|
#define _ATH_AH_SOC_H_
|
|
/*
|
|
* Atheros System on Chip (SoC) public definitions.
|
|
*/
|
|
|
|
/*
|
|
* This is board-specific data that is stored in a "known"
|
|
* location in flash. To find the start of this data search
|
|
* back from the (aliased) end of flash by 0x1000 bytes at a
|
|
* time until you find the string "5311", which marks the
|
|
* start of Board Configuration. Typically one gives up if
|
|
* more than 500KB is searched.
|
|
*/
|
|
struct ar531x_boarddata {
|
|
u_int32_t magic; /* board data is valid */
|
|
#define AR531X_BD_MAGIC 0x35333131 /* "5311", for all 531x platforms */
|
|
u_int16_t cksum; /* checksum (starting with BD_REV 2) */
|
|
u_int16_t rev; /* revision of this struct */
|
|
#define BD_REV 4
|
|
char boardName[64]; /* Name of board */
|
|
u_int16_t major; /* Board major number */
|
|
u_int16_t minor; /* Board minor number */
|
|
u_int32_t config; /* Board configuration */
|
|
#define BD_ENET0 0x00000001 /* ENET0 is stuffed */
|
|
#define BD_ENET1 0x00000002 /* ENET1 is stuffed */
|
|
#define BD_UART1 0x00000004 /* UART1 is stuffed */
|
|
#define BD_UART0 0x00000008 /* UART0 is stuffed (dma) */
|
|
#define BD_RSTFACTORY 0x00000010 /* Reset factory defaults stuffed */
|
|
#define BD_SYSLED 0x00000020 /* System LED stuffed */
|
|
#define BD_EXTUARTCLK 0x00000040 /* External UART clock */
|
|
#define BD_CPUFREQ 0x00000080 /* cpu freq is valid in nvram */
|
|
#define BD_SYSFREQ 0x00000100 /* sys freq is set in nvram */
|
|
#define BD_WLAN0 0x00000200 /* Enable WLAN0 */
|
|
#define BD_MEMCAP 0x00000400 /* CAP SDRAM @ memCap for testing */
|
|
#define BD_DISWATCHDOG 0x00000800 /* disable system watchdog */
|
|
#define BD_WLAN1 0x00001000 /* Enable WLAN1 (ar5212) */
|
|
#define BD_ISCASPER 0x00002000 /* FLAG for AR2312 */
|
|
#define BD_WLAN0_2G_EN 0x00004000 /* FLAG for radio0_2G */
|
|
#define BD_WLAN0_5G_EN 0x00008000 /* FLAG for radio0_2G */
|
|
#define BD_WLAN1_2G_EN 0x00020000 /* FLAG for radio0_2G */
|
|
#define BD_WLAN1_5G_EN 0x00040000 /* FLAG for radio0_2G */
|
|
u_int16_t resetConfigGpio; /* Reset factory GPIO pin */
|
|
u_int16_t sysLedGpio; /* System LED GPIO pin */
|
|
|
|
u_int32_t cpuFreq; /* CPU core frequency in Hz */
|
|
u_int32_t sysFreq; /* System frequency in Hz */
|
|
u_int32_t cntFreq; /* Calculated C0_COUNT frequency */
|
|
|
|
u_int8_t wlan0Mac[6];
|
|
u_int8_t enet0Mac[6];
|
|
u_int8_t enet1Mac[6];
|
|
|
|
u_int16_t pciId; /* Pseudo PCIID for common code */
|
|
u_int16_t memCap; /* cap bank1 in MB */
|
|
|
|
/* version 3 */
|
|
u_int8_t wlan1Mac[6]; /* (ar5212) */
|
|
};
|
|
|
|
/*
|
|
* Board support data. The driver is required to locate
|
|
* and fill-in this information before passing a reference to
|
|
* this structure as the HAL_BUS_TAG parameter supplied to
|
|
* ath_hal_attach.
|
|
*/
|
|
struct ar531x_config {
|
|
const struct ar531x_boarddata *board; /* board config data */
|
|
const char *radio; /* radio config data */
|
|
int unit; /* unit number [0, 1] */
|
|
void *tag; /* bus space tag */
|
|
};
|
|
#endif /* _ATH_AH_SOC_H_ */
|