84 lines
3.5 KiB
C
84 lines
3.5 KiB
C
/* $NetBSD: am9516.h,v 1.1 1995/10/29 21:19:06 gwr Exp $ */
|
|
|
|
/*
|
|
* This file is derived from the file dev/devSCSI3.c from
|
|
* the Berkeley SPRITE distribution, which says:
|
|
*
|
|
* Copyright 1988 Regents of the University of California
|
|
* Permission to use, copy, modify, and distribute this
|
|
* software and its documentation for any purpose and without
|
|
* fee is hereby granted, provided that the above copyright
|
|
* notice appear in all copies. The University of California
|
|
* makes no representations about the suitability of this
|
|
* software for any purpose. It is provided "as is" without
|
|
* express or implied warranty.
|
|
*/
|
|
|
|
/*
|
|
* AMD 9516 UDC (Universal DMA Controller) Registers.
|
|
* This is used only in the OBIO version (3/50,3/60).
|
|
*/
|
|
|
|
/* addresses of the udc registers accessed directly by driver */
|
|
#define UDC_ADR_MODE 0x38 /* master mode register */
|
|
#define UDC_ADR_COMMAND 0x2e /* command register (write only) */
|
|
#define UDC_ADR_STATUS 0x2e /* status register (read only) */
|
|
#define UDC_ADR_CAR_HIGH 0x26 /* chain addr reg, high word */
|
|
#define UDC_ADR_CAR_LOW 0x22 /* chain addr reg, low word */
|
|
#define UDC_ADR_CARA_HIGH 0x1a /* cur addr reg A, high word */
|
|
#define UDC_ADR_CARA_LOW 0x0a /* cur addr reg A, low word */
|
|
#define UDC_ADR_CARB_HIGH 0x12 /* cur addr reg B, high word */
|
|
#define UDC_ADR_CARB_LOW 0x02 /* cur addr reg B, low word */
|
|
#define UDC_ADR_CMR_HIGH 0x56 /* channel mode reg, high word */
|
|
#define UDC_ADR_CMR_LOW 0x52 /* channel mode reg, low word */
|
|
#define UDC_ADR_COUNT 0x32 /* number of words to transfer */
|
|
|
|
/*
|
|
* For a dma transfer, the appropriate udc registers are loaded from a
|
|
* table in memory pointed to by the chain address register.
|
|
*/
|
|
struct udc_table {
|
|
u_short rsel; /* tells udc which regs to load */
|
|
u_short addrh; /* high word of main mem dma address */
|
|
u_short addrl; /* low word of main mem dma address */
|
|
u_short count; /* num words to transfer */
|
|
u_short cmrh; /* high word of channel mode reg */
|
|
u_short cmrl; /* low word of channel mode reg */
|
|
};
|
|
|
|
/* indicates which udc registers are to be set based on info in above table */
|
|
#define UDC_RSEL_RECV 0x0182
|
|
#define UDC_RSEL_SEND 0x0282
|
|
|
|
/* setting of chain mode reg: selects how the dma op is to be executed */
|
|
#define UDC_CMR_HIGH 0x0040 /* high word of channel mode reg */
|
|
#define UDC_CMR_LSEND 0x00c2 /* low word of cmr when send */
|
|
#define UDC_CMR_LRECV 0x00d2 /* low word of cmr when receiving */
|
|
|
|
/* setting for the master mode register */
|
|
#define UDC_MODE 0xd /* enables udc chip */
|
|
|
|
/* setting for the low byte in the high word of an address */
|
|
#define UDC_ADDR_INFO 0x40 /* inc addr after each word is dma'd */
|
|
|
|
/* udc commands */
|
|
#define UDC_CMD_STRT_CHN 0xa0 /* start chaining */
|
|
#define UDC_CMD_CIE 0x32 /* channel 1 interrupt enable */
|
|
#define UDC_CMD_RESET 0x00 /* reset udc, same as hdw reset */
|
|
|
|
/* bits in the udc status register */
|
|
#define UDC_SR_CIE 0x8000 /* channel interrupt enable */
|
|
#define UDC_SR_IP 0x2000 /* interrupt pending */
|
|
#define UDC_SR_CA 0x1000 /* channel abort */
|
|
#define UDC_SR_NAC 0x0800 /* no auto reload or chaining*/
|
|
#define UDC_SR_WFB 0x0400 /* waiting for bus */
|
|
#define UDC_SR_SIP 0x0200 /* second interrupt pending */
|
|
#define UDC_SR_HM 0x0040 /* hardware mask */
|
|
#define UDC_SR_HRQ 0x0020 /* hardware request */
|
|
#define UDC_SR_MCH 0x0010 /* match on upper comparator byte */
|
|
#define UDC_SR_MCL 0x0008 /* match on lower comparator byte */
|
|
#define UDC_SR_MC 0x0004 /* match condition ended dma */
|
|
#define UDC_SR_EOP 0x0002 /* eop condition ended dma */
|
|
#define UDC_SR_TC 0x0001 /* termination of count ended dma */
|
|
|