NetBSD/sys/arch/sun3/dev/sereg.h

114 lines
4.3 KiB
C

/* $NetBSD: sereg.h,v 1.3 1997/12/08 19:17:12 gwr Exp $ */
/*-
* Copyright (c) 1997 The NetBSD Foundation, Inc.
* All rights reserved.
*
* This code is derived from software contributed to The NetBSD Foundation
* by Gordon W. Ross.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. All advertising materials mentioning features or use of this software
* must display the following acknowledgement:
* This product includes software developed by the NetBSD
* Foundation, Inc. and its contributors.
* 4. Neither the name of The NetBSD Foundation nor the names of its
* contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
* TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
* PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
* BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
* CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
* CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*/
/*
* Sun3/E SCSI/Ethernet board. This is a VME board with some memory,
* an Intel Ether, and an NCR5380 SCSI with a cheap DMA engine.
* The Sun3/E H/W manual says the ivec2 register is at offset 1E,
* but the SunOS sereg.h file has it at offset 1F (more likely).
* Perhaps the H/W really implements a short at 1E or something.
*/
/*****************************************************************
* Register definitions for the SCSI portion.
* (size=0x20)
*/
struct se_regs {
u_char ncrregs[8];
u_short unused1;
u_short dma_addr; /* DMA offset register */
u_short unused2;
u_short dma_cntr; /* DMA count down register */
u_short unused3[5];
u_short se_csr; /* control/status register */
u_short unused4;
u_short se_ivec; /* interrupt vector */
};
/*
* SCSI Control and Status Register.
* Note:
* (ro) indicates bit is read only.
* (rw) indicates bit is read or write.
*/
#define SE_CSR_SBC_IP 0x0200 /* (ro) sbc interrupt pending */
#define SE_CSR_SEND 0x0008 /* (rw) dma dir, 1=to device */
#define SE_CSR_INTR_EN 0x0004 /* (rw) interrupts enable */
#define SE_CSR_VCC 0x0002 /* (ro) power signal to the chip */
#define SE_CSR_SCSI_RES 0x0001 /* (rw) reset sbc and udc, 0=reset */
/*****************************************************************
* Register definitions for the SCSI portion.
* (size=0x100)
*/
struct ie_regs {
u_short ie_pad0;
u_short ie_csr;
u_short ie_pad1[7];
u_short ie_ivec; /* interrupt vector */
u_short ie_pad3[128-10];
};
/*
* Ether Control and Status Register.
*/
#define IE_CSR_RESET 0x8000 /* board reset */
#define IE_CSR_NOLOOP 0x4000 /* loopback disable */
#define IE_CSR_ATTEN 0x2000 /* channel attention */
#define IE_CSR_IENAB 0x1000 /* interrupt enable */
#define IE_CSR_IPEND 0x0100 /* interrupt pending */
/*****************************************************************
* Register definitions for the entire SCSI/Ethernet board.
* I had the impression that there were overlaps in this map,
* which was the reason for existence of the "sebuf" driver.
* Now it looks like the "sebuf" driver was unnecessary. XXX
*/
#define SE_NCRBUFSIZE 0x10000
#define SE_IEBUFSIZE 0x20000
struct sebuf_regs {
char se_scsi_buf[SE_NCRBUFSIZE];
struct se_regs se_scsi_regs;
char se_pad[0x10000 - 0x120];
struct ie_regs se_eth_regs;
char se_eth_buf[SE_IEBUFSIZE];
}; /* 128KB total */