NetBSD/share/man/man4/stf.4

280 lines
8.4 KiB
Groff

.\" $NetBSD: stf.4,v 1.21 2006/06/17 04:58:14 reed Exp $
.\" $KAME: stf.4,v 1.39 2002/11/17 19:34:02 itojun Exp $
.\"
.\" Copyright (C) 1995, 1996, 1997, and 1998 WIDE Project.
.\" All rights reserved.
.\"
.\" Redistribution and use in source and binary forms, with or without
.\" modification, are permitted provided that the following conditions
.\" are met:
.\" 1. Redistributions of source code must retain the above copyright
.\" notice, this list of conditions and the following disclaimer.
.\" 2. Redistributions in binary form must reproduce the above copyright
.\" notice, this list of conditions and the following disclaimer in the
.\" documentation and/or other materials provided with the distribution.
.\" 3. Neither the name of the project nor the names of its contributors
.\" may be used to endorse or promote products derived from this software
.\" without specific prior written permission.
.\"
.\" THIS SOFTWARE IS PROVIDED BY THE PROJECT AND CONTRIBUTORS ``AS IS'' AND
.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
.\" ARE DISCLAIMED. IN NO EVENT SHALL THE PROJECT OR CONTRIBUTORS BE LIABLE
.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
.\" SUCH DAMAGE.
.\"
.Dd March 24, 2004
.Dt STF 4
.Os
.Sh NAME
.Nm stf
.Nd 6to4 tunnel interface
.Sh SYNOPSIS
.Cd "pseudo-device stf"
.Sh DESCRIPTION
The
.Nm
interface supports
.Dq 6to4
IPv6 in IPv4 encapsulation.
It can tunnel IPv6 traffic over IPv4, as specified in
.Li RFC3056 .
.Nm
interfaces are dynamically created and destroyed with the
.Xr ifconfig 8
.Cm create
and
.Cm destroy
subcommands. Only one
.Nm
interface may be created.
.Pp
For ordinary nodes in 6to4 sites, you do not need a
.Nm
interface.
The
.Nm
interface is only necessary on the site border router
.Po
called the
.Dq 6to4 router
in the specification
.Pc .
.Pp
Due to the way the 6to4 protocol is specified,
.Nm
interfaces require certain configuration to work properly.
A single
.Pq no more than one
valid 6to4 address needs to be configured on the interface.
.Dq A valid 6to4 address
is an address which has the following properties.
If any of the following properties are not satisfied,
.Nm stf
raises a runtime error on packet transmission.
Read the specification for more details.
.Bl -bullet
.It
matches
.Li 2002:xxyy:zzuu::/48 ,
where
.Li xxyy:zzuu
is the hexadecimal notation of an IPv4 address for the node.
The IPv4 address used can be taken from any interface your node has.
Since the specification forbids the use of IPv4 private address,
the address needs to be a global IPv4 address.
.It
Subnet identifier portion
.Pq 48th to 63rd bit
and interface identifier portion
.Pq lower 64 bits
are properly filled to avoid address collisions.
.El
.Pp
If you would like the node to behave as a relay router,
the prefix length for the IPv6 interface address needs to be 16 so that
the node would consider any 6to4 destination as
.Dq on-link .
If you would like to restrict 6to4 peers to be inside a certain IPv4 prefix,
you may want to configure the IPv6 prefix length to be
.Dq 16 + IPv4 prefix length .
The
.Nm
interface will check the IPv4 source address on packets
if the IPv6 prefix length is larger than 16.
.Pp
.Nm
can be configured to be ECN (Explicit Congestion Notification) friendly.
This can be configured by
.Dv IFF_LINK1 .
See
.Xr gif 4
for details.
.Pp
Please note that the 6to4 specification is written as an
.Dq accept tunneled packet from everyone
tunneling device.
By enabling the
.Nm
device, you are making it much easier for malicious parties to inject
fabricated IPv6 packets to your node.
Also, malicious parties can inject IPv6 packets with fabricated source addresses
to make your node generate improper tunneled packets.
Administrators must be cautious when enabling the interface.
To prevent possible attacks, the
.Nm
interface filters out the following packets (note that the checks are
in no way complete):
.Bl -bullet
.It
Packets with IPv4 unspecified addresses as outer IPv4 source/destination
.Pq Li 0.0.0.0/8
.It
Packets with the loopback address as outer IPv4 source/destination
.Pq Li 127.0.0.0/8
.It
Packets with IPv4 multicast addresses as outer IPv4 source/destination
.Pq Li 224.0.0.0/4
.It
Packets with limited broadcast addresses as outer IPv4 source/destination
.Pq Li 255.0.0.0/8
.It
Packets with private addresses as outer IPv4 source/destination
.Pq Li 10.0.0.0/8, 172.16.0.0/12, 192.168.0.0/16
.It
Packets with IPv4 link-local addresses as outer IPv4 source/destination
.Pq Li 169.254.0.0/16
.It
Packets with subnet broadcast addresses as outer IPv4 source/destination.
The check is made against subnet broadcast addresses for
all of the directly connected subnets.
.It
Packets that do not pass ingress filtering.
Outer IPv4 source addresses must meet the IPv4 topology on the routing table.
Ingress filtering can be turned off by
.Dv IFF_LINK2
bit.
.It
The same set of rules are applied against the IPv4 address embedded into
the inner IPv6 address, if the IPv6 address matches the 6to4 prefix.
.It
Packets with site-local or link-local unicast addresses as
inner IPv6 source/destination
.It
Packets with node-local or link-local multicast addresses as
inner IPv6 source/destination
.El
.Pp
It is recommended to filter/audit
incoming IPv4 packets with IP protocol number 41, as necessary.
It is also recommended to filter/audit encapsulated IPv6 packets as well.
You may also want to run normal ingress filtering against inner IPv6 addresses
to avoid spoofing.
.Pp
By setting the
.Dv IFF_LINK0
flag on the
.Nm
interface, it is possible to disable the input path,
making direct attacks from the outside impossible.
Note, however, that other security risks exist.
If you wish to use the configuration,
you must not advertise your 6to4 addresses to others.
.\"
.Sh EXAMPLES
Note that
.Li 8504:0506
is equal to
.Li 133.4.5.6 ,
written in hexadecimal.
.Bd -literal
# ifconfig ne0 inet 133.4.5.6 netmask 0xffffff00
# ifconfig stf0 create inet6 2002:8504:0506:0000:a00:5aff:fe38:6f86 \\
prefixlen 16 alias
.Ed
.Pp
The following configuration accepts packets from IPv4 source address
.Li 9.1.0.0/16
only.
It emits 6to4 packets only for IPv6 destination 2002:0901::/32
.Pq IPv4 destination will match Li 9.1.0.0/16 .
.Bd -literal
# ifconfig ne0 inet 9.1.2.3 netmask 0xffff0000
# ifconfig stf0 create inet6 2002:0901:0203:0000:a00:5aff:fe38:6f86 \\
prefixlen 32 alias
.Ed
.Pp
The following configuration uses the
.Nm
interface as an output-only device.
You need to have alternative IPv6 connectivity
.Pq other than 6to4
to use this configuration.
For outbound traffic, you can reach other 6to4 networks efficiently via
.Nm stf .
For inbound traffic, you will not receive any 6to4-tunneled packets
.Pq less security drawbacks .
Be careful not to advertise your 6to4 prefix to others
.Pq Li 2002:8504:0506::/48 ,
and not to use your 6to4 prefix as a source address.
.Bd -literal
# ifconfig ne0 inet 133.4.5.6 netmask 0xffffff00
# ifconfig stf0 create inet6 2002:8504:0506:0000:a00:5aff:fe38:6f86 \\
prefixlen 16 alias deprecated link0
# route add -inet6 2002:: -prefixlen 16 ::1 -ifp stf0
.Ed
.\"
.Sh SEE ALSO
.Xr gif 4 ,
.Xr inet 4 ,
.Xr inet6 4
.Pp
.Pa http://www.6bone.net/6bone_6to4.html
.Rs
.%A Brian Carpenter
.%A Keith Moore
.%T "Connection of IPv6 Domains via IPv4 Clouds"
.%D February 2001
.%R RFC
.%N 3056
.Re
.Rs
.%A F. Baker
.%A P. Savola
.%T "Ingress Filtering for Multihomed Networks"
.%D March 2004
.%R RFC
.%N 3704
.Re
.Rs
.%A Jun-ichiro itojun Hagino
.%T "Possible abuse against IPv6 transition technologies"
.%D July 2000
.%N draft-itojun-ipv6-transition-abuse-01.txt
.%O work in progress
.Re
.\"
.Sh HISTORY
The
.Nm
device first appeared in WIDE/KAME IPv6 stack.
.\"
.Sh BUGS
No more than one
.Nm
interface is allowed for a node,
and no more than one IPv6 interface address is allowed for an
.Nm
interface.
This is to avoid source address selection conflicts
between the IPv6 layer and the IPv4 layer,
and to cope with ingress filtering rules on the other side.
This is a feature to make
.Nm
work right for all occasions.