NetBSD/atari 1.2 runs on a TT030 and a Falcon. An FPU is not required. The
minimum amount of RAM required is 4Mb.

Here is a table of recommended HD partition sizes for a full install:
	partition:	advise,	with X,	needed,	with X
	root (/)	15M	15M	10M	10M
	user (/usr)	65M	100M	45M 	80M
	swap		----- 2M for every M ram (see below) -----
	local (/local)	up to you

In addition of the rule of thumb for the swap size mentioned below, you
probably want to make sure that the size of the swap partition does not
drop below 20Mb (30Mb for systems with X).
As you may note the recommended size of /usr is 20M greater than
needed. This is to leave room for a kernel source and compile tree
as you will probably want to compile your own kernel. (GENERIC is
large and bulky to accommodate all people, BOOT is small and might
not have all the features you want).

Supported devices include:
	- The builtin SCSI host adapter
		- Should support most SCSI-drives. The drives that are
		  currently tested are:
			MAXTOR 7245S, MAXTOR 7080S, SEAGATE ST157N
		- Should support most tape drives. The drives that are
		  currently tested are:
			TANDBERG 3600
		- Should support most CD-ROM drives.
		- Should support most ZIP/MO drives.
	- The builtin video controller
	- The builtin (720Kb/1.44Mb) floppydrive
	- The serial2/modem2 ports
	- The Falcon FX memory expansion
	- The atari mouse
	- A 3-button mouse
	- The parallel printer

If it's not on this list, there is no support for it in this release.