# $NetBSD: ALL,v 1.36 2000/06/14 22:02:42 veego Exp $ # # ALL -- everything that's currently supported # include "arch/x68k/conf/std.x68k" #ident "ALL-$Revision: 1.36 $" maxusers 32 ## System kernel configuration. See options(4) for more detail. ## Options for variants of the m68k MPU ## you must have at least the correct one; REQUIRED options M68030 options M68040 options M68060 #### System options specific to the x68k port options EXTENDED_MEMORY # support for >16MB memory options FPU_EMULATE # software fpu emulation for MC68030 options FPSP # floating point emulation for MC68040 options M060SP # int/fp emulation for MC68060 options JUPITER # support for "Jupiter-X" accelerator options MAPPEDCOPY # use page mapping for large copyin/copyout #options ZSCONSOLE,ZSCN_SPEED="9600" # use serial console #### System options that are the same for all ports ## Root device configuration: change the ?'s if you are going to use a ## nonstandard root partition (other than where the kernel is booted from) ## and/or nonstandard root type (not ffs or nfs). Normally this can be ## automagically determined at boot time. config netbsd root on ? type ? #config netbsd root on sd0 type ffs ## RTC is offset from GMT; -540 means JST-9 options RTC_OFFSET=-540 # hardware clock is this many mins. west of GMT ## System call tracing (see ktrace(1)). options KTRACE ## Collect statistics on kernel malloc's and free's. This does have a ## significant performance hit on slower machines, so it is intended for ## diagnostic use only. options KMEMSTATS ## System V compatible IPC subsystem. (msgctl(2), semctl(2), and shmctl(2)) options SYSVMSG # System V message queues options SYSVSEM # System V semaphores options SYSVSHM # System V shared memory #options SHMMAXPGS=1024 # 1024 pages is the default ## Loadable kernel module support options LKM ## NFS boot options; not supported currently: needs nfsboot program #options NFS_BOOT_BOOTPARAM #options NFS_BOOT_BOOTP #options NFS_BOOT_DHCP #### Debugging options ## The DDB in-kernel debugger runs at panic (unless DDB_ONPANIC=0), or at ## serial console break or keyboard reset, where the PROM would normally ## intercept. DDB_HISTORY_SIZE adds up/down arrow command history. options DDB # kernel dynamic debugger options DDB_HISTORY_SIZE=100 # enable history editing in DDB #options DDB_ONPANIC=1 # see also sysctl(8): `ddb.onpanic' options PANICBUTTON # interrupt switch invokes DDB ## You may also use gdb, on another computer connected to this machine over ## a serial port. Both KGDBDEV and KGDBRATE should be specified; KGDBDEV is ## a dev_t encoded device number of the serial port to use. ## KGDB is not supported for now. #options KGDB # support for kernel gdb #options KGDBDEV=0xc00 # kgdb device number #options KGDBRATE=9600 # baud rate ## Compile the kernel with debugging symbols (`netbsd.gdb' is the debug file), ## such that gdb(1) can be used on a kernel coredump. #makeoptions DEBUG="-g" ## Adds code to the kernel that does internal consistency checks, and will ## cause the kernel to panic if corruption of internal data structures ## is detected. options DIAGNOSTIC # extra kernel sanity checking ## Enable (possibly expensive) debugging code that may also display messages ## on the system console options DEBUG ## Make SCSI error messages more verbose when explaining their meanings. options SCSIVERBOSE ## `INSECURE' turns off the kernel security level (securelevel = 0 always). ## This allows writing to /dev/mem, loading kernel modules while multi-user, ## and other insecurities good only for development work. Do not use this ## option on a production machine. #options INSECURE ## Allow non-root users to grab /dev/console with programs such as xconsole. ## `xconsole' therefore does not need setuid root with this option enabled. #options UCONSOLE ## `FDSCRIPTS' allows non-readable but executable scripts by providing a ## pre-opened opaque file to the script interpreter. `SETUIDSCRIPTS', ## which implies FDSCRIPTS, allows scripts to be set-user-id using the same ## opaque file mechanism. Perl calls this "secure setuid scripts." #options FDSCRIPTS #options SETUIDSCRIPTS ## Options for compatibility with previous releases foreign system binaries. options COMPAT_43 # 4.3BSD system interfaces options COMPAT_09 # NetBSD 0.9 binary compatibility options COMPAT_10 # NetBSD 1.0 binary compatibility options COMPAT_11 # NetBSD 1.1 binary compatibility options COMPAT_12 # NetBSD 1.2 binary compatibility options COMPAT_13 # NetBSD 1.3 binary compatibility options COMPAT_14 # NetBSD 1.4 binary compatibility options COMPAT_M68K4K # NetBSD/m68k4k binaries #options COMPAT_SUNOS # SunOS 4.x binary compatibility; broken options COMPAT_SVR4 # SVR4 binary compatibility; broken options COMPAT_LINUX # Linux/m68k binary compatibility options EXEC_ELF32 # 32-bit ELF executables (Linux, SVR4) ## File systems. file-system FFS # Berkeley Fast Filesystem file-system NFS # Sun NFS-compatible filesystem client file-system KERNFS # kernel data-structure filesystem file-system NULLFS # NULL layered filesystem (buggy) file-system OVERLAY # overlay file system file-system MFS # memory-based filesystem file-system FDESC # user file descriptor filesystem file-system UMAPFS # uid/gid remapping filesystem file-system LFS # Log-structured filesystem (experimental) file-system PORTAL # portal filesystem (experimental) file-system PROCFS # /proc file-system CD9660 # ISO 9660 + Rock Ridge file system file-system UNION # union file system (a little buggy) file-system MSDOSFS # MS-DOS FAT filesystem(s). file-system ADOSFS # AmigaDOS filesystem ## File system options. options NFSSERVER # Sun NFS-compatible filesystem server options QUOTA # FFS quotas options FFS_EI # FFS Endian Independent support options SOFTDEP # FFS soft updates support. ## Network protocol support. In most environments, INET is required. options INET # IP (Internet Protocol) v4 options INET6 # IPV6 options IPSEC # IP security options IPSEC_ESP # IP security (encryption part; define w/IPSEC) options IPSEC_DEBUG # debug for IP security options TCP_COMPAT_42 # 4.2BSD IP implementation compatibility options GATEWAY # packet forwarding ("router switch") options MROUTING # packet forwarding of multicast packets #options DIRECTED_BROADCAST # allow broadcasts through routers options NS # Xerox NS networking #options NSIP # Xerox NS tunneling over IP options ISO,TPIP # OSI networking options EON # OSI tunneling over IP #options CCITT,LLC,HDLC # X.25 packet switched protocol options NETATALK # AppleTalk (over Ethernet) protocol options NTP # Network Time Protocol in-kernel support #options PPS_SYNC # Add serial line synchronization for NTP options PFIL_HOOKS # Add pfil(9) hooks, intended for custom LKMs. options IPFILTER_LOG # Add ipmon(8) logging for ipfilter device options PPP_BSDCOMP # Add BSD compression to ppp device options PPP_DEFLATE # Add deflate (libz) compression to ppp device options PPP_FILTER # Add active filters for ppp (via bpf) #### Device configurations ## Fundamental devices; see also std.x68k dmac0 at intio0 addr 0xe84000 # DMA controler xel0 at intio0 opm0 at intio0 addr 0xe90000 # OPM: required for fdc ## Display devices and console grfbus0 at mainbus0 # bitmapped displays grf0 at grfbus0 # multiplane graphics grf1 at grfbus0 # flexible graphics kbd0 at mfp0 # standard keyboard ite0 at grf0 # internal terminal emulator options ITE_KERNEL_ATTR=4 # bold for kernel messages # see /sys/arch/x68k/dev/itevar.h pseudo-device pow 2 # software power switch ## floppy disks fdc0 at intio0 addr 0xe94000 intr 96 dma 0 dmaintr 100 # floppy controler fd* at fdc0 unit ? # builtin floppy drives ## SCSI devices scsirom0 at intio0 addr 0xfc0000 # Built-in SCSI BIOS scsirom1 at intio0 addr 0xea0020 # External SCSI BIOS spc0 at scsirom0 # genuin SCSI spc1 at scsirom1 # genuin SCSI scsibus* at spc? mha0 at scsirom1 # Mankai MK-HA1 (Mach-2) scsibus* at mha0 sd* at scsibus? target ? lun ? # SCSI disks cd* at scsibus? target ? lun ? # SCSI CD-ROMs st* at scsibus? target ? lun ? # SCSI tapes ss* at scsibus? target ? lun ? # SCSI scanners ch* at scsibus? target ? lun ? # SCSI changer devices uk* at scsibus? target ? lun ? # SCSI unknown devices ## Ports zsc0 at intio0 addr 0xe98000 intr 112 zstty0 at zsc0 channel 0 # built-in RS-232C ms0 at zsc0 channel 1 # standard mouse zsc1 at intio0 addr 0xeafc00 intr 113 zstty2 at zsc1 channel 0 zstty3 at zsc1 channel 1 zsc2 at intio0 addr 0xeafc10 intr 114 zstty4 at zsc2 channel 0 zstty5 at zsc2 channel 1 par0 at intio0 addr 0xe8c000 # Builtin printer port pseudo-device sram # battery-backuped static RAM pseudo-device bell # OPM bell xcom0 at mainbus0 # NS16550 fast serial xcom1 at mainbus0 ## Audio device; broken #okiadpcm0 at intio0 addr 0xe92000 intr 106 errintr 107 dma 3 #audio* at okiadpcm* ## Network interfaces neptune0 at intio0 addr 0xece000 intr 249 # Neptune-X neptune1 at intio0 addr 0xece400 intr 249 # Neptune-X at alt. addr. ne0 at neptune? addr 0x300 # NE2000 or clone #se0 at scsibus? target ? lun ? # Ether+; broken #### Pseudo devices ## A disk-like interface to files. Can be used to create floppy, CD, ## miniroot images, etc. pseudo-device vnd 4 ## Concatenated and striped disks; with this, you can create a software-based ## disk array similar to a "RAID 0" setup. See ccd(4). pseudo-device ccd 4 ## RAIDframe disk driver: software RAID driver. See raid(4). pseudo-device raid 4 #options RAID_AUTOCONFIG # auto-configuration of RAID components ## Memory disk device, used on boot floppies with compressed ## kernel-plus-root-disk images. #pseudo-device md 1 ## Loopback network interface; required pseudo-device loop ## SLIP and CSLIP interfaces, for IP over a serial line. pseudo-device sl 2 ## PPP, the successor to SLIP. See pppd(8). pseudo-device ppp 2 ## Network "tunnel" device, allowing protocol stacks to run in the userland. ## This is used by the third-party user-mode "ppp" program, and others. pseudo-device tun 4 ## Generic L3 over IP tunnel #pseudo-device gre 2 # generic L3 over IP tunnel ## Berkeley Packet Filter, required to run RARPD. A generic C-language ## interface that allows selective examining of incoming packets. pseudo-device bpfilter 8 ## IP Filter, used in firewall and NAT applications. See ipnat(8) for ## one example of the use of the IP Filter. pseudo-device ipfilter ## for IPv6 pseudo-device gif 4 # IPv[46] over IPv[46] tunnel (RFC1933) #pseudo-device faith 1 # IPv[46] tcp relay translation i/f #### Other device configuration ## Pseudo ttys, required for network logins and programs like screen. ## 32 is a good number for average systems; you may have as many as you ## like, though 256 is more or less the upper limit. Increasing this ## number still requires you to run /dev/MAKEDEV to create the files ## for the ptys. pseudo-device pty 32 # pseudo-ttys (for network, etc.) ## Random device, used to implement /dev/random (a source of random noise), ## and generate randomness for some kernel formulae. pseudo-device rnd